Overview of Status of Analysis, Design, Fabrication, Tests, etc.
Machined linear alternator
Circuit built and tested for charging capacitor
Handle CAD design still needs work but close to finish
Accomplishments from Previous Week
Power generation components have been purchased and validated
Report updated
Machined PVC pipe to get the desired dimensions
Handle 3D CAD updated
Heads CAD updated
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Finish CAD for handle - Ariyan
3D Print new handle - Chris/Ariyan
Assemble handle with power-gen circuitry and existing scope heads - Everyone
Revise Report - Everyone
Use equations to predict smallest possible design for inductor
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Handle too large, too many organic curves for fingers
Actions Taken: Handle design adjusted to be thinner, have less grooves, and more geometric/modern design
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Validate theoretical voltage and power calculations for linear inductor
Actions Taken: Conducted experiments with oscilloscopes and loads on our inductor to measure power
Test limits of size of inductor
Actions Taken: Inductor reduced in size by machining down the outer diameter of existing pipe and using lathe to re-coil wire
Will use theoretical equations to see optimal size/length of inductor as well as determine minimum requirements
Comments from Other Students in the Class (indicate date of comments and if via email or in person)
Use videos to demonstrate power generation
Actions taken: Recorded video of magnet passing through mechanism while connected to the oscilloscope
Risks and Areas of Concern
Fitting circuitry inside handle
Circuit able to output light
Handle must be rigid to withstand shaking
Resources or Information Required but not Available
N/A
Schedule
End of this week: Have a prototype working with existing heads
Budget (list amount spent and amount remaining)
Budget
Expenses
Total Remaining
$1,000.00
$237.45
$762.55
Progress on Report and Webpage
Still need to add more useful figures such as CAD, circuit diagram, and pictures of power generator