WEEK 5

PREFACE TO WORK

It is necessary to have a good hardware setup to collect the data. The setup should have following features.

* The distance between the contact point and the center of the antenna can be varied.

* All the times that the antenna hit the material should give approximately equal impulses.

* The contact material should be changed .

PROGRESS

According to the design of the previous week , the setup was successfully finished and following materials were used . The knowledge gain from the research papers and advises from the advisers were used to choose methods and materials.

• Antenna - Acrylic fiber tube 400 mm long , ID 8 mm , OD 10 mm
• MG 996R servo motor
• MPU 6050 accelerometer

RESULTS

The setup that design to collect the data was implemented and the shown in Figure 06.

Figure 06: Data collecting setup

REFERENCE