156B Week 10
Overview of Status of Analysis, Design, Fabrication, Tests, etc.
Final model has been completed!
Motor is able to handle the torque of the pulley system and does not stall at low speeds.
Noise was found to be negligible.
Vibrations are negligible.
Final CAD model has been updated.
Accomplishments from Previous Week
Troubleshooted issues with the previous model
Reduce the thickness of the wire for the brush holders.
Purchased a higher torque motor
Designed a motor mount for the new device.
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Prepare for final presentation.
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
N/A
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
N/A
Comments from Other Students in the Class (indicate date of comments and if via email or in person)
N/A
Risks and Areas of Concern
Brush holders are a bit difficult to replace
Tensioning the belt is a time consuming process that may be hard for the sponsor to adjust if needed.
Resources or Information Required but not Available
N/A
Schedule
6/08/20: Present to Dr. Case
6/10/20: Present final presentation to class
Budget (list amount spent and amount remaining)
Total Spent: $1157.15
Total Remaining: $542.85
Progress on Report and Webpage
Report has been completed.
Final presentation slides have been added to the site.
Final deliverables have been added to the site.
Webpage has been updated to reflect the final model.