How to install wall panels in bathroom

Following these detailed guidelines can make installing wall panels in a bathroom a simple and easy process:

1. Prepare the Surface:

• Verify that the walls are dry, clean, and clear of any oil, dirt, or wall coverings that may still be there, such as wallpaper or tiles.

• Make sure the walls are level and smooth, and fix any damage that may have occurred. If needed, smooth down any uneven areas.

2. Measure and Cut Panels:

• Use a tape measure to precisely measure the bathroom walls' size.

• Trace these measurements onto the wall panels, then use a pencil to mark the cutting lines.

• To ensure a secure fit, precisely trim the panels to the desired size using a saw or other cutting instrument.

3. Plan the Layout:

• To guarantee that the panels will fit uniformly across the walls, prepare the arrangement before placing the panels.

• Plan the panel arrangement taking into account where fixtures like sinks, toilets, and showers are located.

4. Install Panels:

• Begin in the bathroom's corner and proceed along the wall.

• If necessary, adhere the first panel's back using glue in accordance with the manufacturer's recommendations. As an alternative, certain panels can feature an easy-to-install tongue-and-groove system.

• Make sure the panel is plumb and level by pressing it firmly against the wall. For accuracy checks, use a level.

• If necessary, use mechanical fasteners like screws or nails to firmly anchor the panel in place. For a secure attachment, push the fasteners through the panel and into the wall studs.

• Continue adding panels until the wall is completely covered, interlocking the edges or overlapping as necessary.

5. Trim Panels:

• As you reach the edges or corners of the walls, you may need to trim the panels to fit properly.

• Use a saw or cutting tool to make precise cuts, ensuring the panels fit snugly against the wall.

6. Seal Joints and Edges:

• Once all panels are installed, seal the joints and edges using silicone caulk or sealant. This helps prevent water from seeping behind the panels and protects against moisture damage.

• Apply a bead of caulk along the edges where panels meet and smooth it out with a caulk tool or your finger for a neat finish.

7. Final Checks:

Verify the installation one more time to look for any loose panels or spaces between panels. Make any required corrections and confirm that every panel is fastened to the wall firmly.