What To Do When You Face TP-Link Wifi Extender Not Working Issue?

Are you tired of dead spots all over your house and can't seem to get adequate internet speed to finish your task? When you have a slow internet connection, this might be aggravating. But not any longer! TP-Link delivers an extension to increase your internet speed and expand your network area. In only a few minutes, you may set up your device. Here you will discover how to set up the TP-Link Extender and how to fix TP-Link Wifi extender not working issue.

Setup Instructions for TP-Link Extenders

If you only need a few easy steps to complete the setup, this is the simplest method for doing so. Please see the information provided below.

· To begin the setup process, connect your router and extender then connect your extender to your computer via Ethernet connection.

· After that, go to your range extender's administration page and choose Network.

· The IP address of your extender should match the IP section, then click the Save button.

· Select Quick Setup, then Wireless. You must first select the range extender before searching.

· Select the SSID name from the list, type in the password, and save.

· To complete the configuration procedure, follow the directions on the screen.

Steps to Resolve TP-Link Extender Not Working Issues

This is the place to go if you're having TP-Link problems and need to figure out how to fix TP-Link extender problems. Follow the instructions below for TP-Link extender troubleshooting:

· You can check to see if your devices are connected properly. You can unplug them and reconnect them properly later.

· Make sure you're using the right web URL or IP address. This could cause issues. Make sure you're using the right login information.

· Make sure your router and range extender are not too far apart.

· Make sure your main router does not have any security settings enabled.

· Check your end device's signal strength. If only one device fails to connect, you can disconnect it and reconnect it.

· You can see if your firmware needs updating. If an update is available, you must upgrade the firmware on your device and see if it works.

· Rebooting your device may resolve the problem.

If nothing else works, you can restore your device to its factory default settings. You must locate the reset button on your device and press it with a small paper pin to accomplish this. After a few seconds, release the button and your device will be set again to the default settings. However, if you need any further help regarding the tp-link wifi extender not working issue, then you can contact our team members.