How to Replace Ribbon Cable of Flydigi Wee 2/2T

Remove three screws and the left hand side after that it should just pop out of the case

Remove the three screws and it should pop out easily the same as the left side

Stretch the controller and put it with its back side facing you

Unscrew the 4 screws connecting it to the middle piece

You can use your phone case to keep it stretched

Stretch the controller one side at a time until it separates from the middle piece
(Do not stretch it too much just until it gets out of the middle piece)

then put them both behind the middle piece because of the metal roller in the middle you can't separate it yet

you will see three screws on the left and three screws on the right

(Sry I couldn't show the right side the roller was retracted when I made this)

Remove the rubber and it should reveal screws

The left side of the controller will reveal three screws while the right side of the controller will reveal 4 screws.

Unscrew them and it should reveal the metal roller and a metal piece

This are the 2 pieces that are very important to the stretching mechanism.

Remove both parts from the controller

Put the other metal piece inside the roller and push it in its original place while preventing it from retracting

If you got it in its original place screw back the cover while holding it in place

If all goes well then it should look something like this

Make sure both sides are equal and after that put electrical tape in place of the adhesive before, make sure that the ribbon cable is not moving around inside the middle piece

To put the rollers back in, match it in with the screw hole and place the cover back

do one side at a time once you got one side in place you can screw it in and then you can just fit the other side by lifting it a little

Make sure you don't accidentally retract the metal roller