2002 Tonka Rodeo Truck before modifications

Prototyping head & tail lights prior to committing to solderable breadboard

Laying out circuit for shift register install to operate the lights

Connecting the LED leads to the board and testing to make sure they all work

Test fitting the shift register board, motor controllers and Arduino

Mounting routed the lighting and securing the wiring

View of the light board installed from inside the cab of the truck

Verifying headlight functioning

Verifying taillight functioning

Mounting the on/off switch. This will be used to route power for all operations

Fitting ultrasonic sensor. Friction fit in this case will be fine

Installed ultrasonic sensor. Alternate view with body temporarily installed

Testing inline motors to controller. Controller will control two motors per side

Pre-wire controller mounting

Installed wheels and motors for the first look at how it comes together

View of the motors mounted and wired in. They have been wired in series so I only need one H-Bridge