Stamped Concrete
Concrete stamping can be a very simple process if you have the right tools and know how to use them properly. However, for most companies, a concrete stamping job will not be finished unless it is properly installed and set with a proper concrete floor. This means that the concrete is first installed in a mold, the molds are fired into place, and the concrete is then pumped into place before the finishing touches are applied.
Finding the proper concrete stamping tools is essential to ensuring this is a process that runs smoothly. For starters, any of the available tools should be able to provide enough lift to support the material being stamped. Some concrete stamping equipment has more strength than others, so do some research before deciding which tools you need to make sure you are using the right ones.
One way of doing this is to measure the panels that you are going to stamp into place. If you are working with concrete that you know will only require minimal support, you can simply use a measuring tape and mark where the panels should be placed on the walls. You may need to re-measure occasionally, but the consistency of your final product will remain consistent as long as you stick to the walls' locations. However, if you are working with a heavier slab or if you are stamping large panel sections at a time, you may need to use heavier equipment to achieve the support needed.
We specialize in Stamped Concrete, Epoxy Flooring, and Garage Floor Coatings
For panel designs that need to be supported strongly, consider installing concrete on a solid level surface. Concrete and mortar can easily become uneven if they are found on an uneven concrete surface. If you need to stay on a level surface while you apply the concrete, consider using a concrete levelling concrete pump.
These pumps are designed to raise the panel by approximately one foot. They can be used on a high traffic area, such as a fence or driveway, but they can also be used to create an uneven seal between concrete. Instead of having the concrete rise in one spot and fall in another, the levelling concrete pump allows the panels to rise and fall in a uniform manner.
The next step in concrete stamping is to place the panels into position. All of the tools that you need to do this will be within easy reach, so take a moment to familiarize yourself with your equipment. For starters, you will need a roller or a grinder for fastening panels into place. Be sure to protect your hands with gloves, because your hands will be very wet during this process.
Once the panels are fastened, you will need to put on the concrete sealer that is most appropriate for the material you are stamping. This is often a translucent spray that is used to help protect the concrete. The best products for sealing concrete are products that are relatively new and/or those that are slightly denser than the concrete.
After your concrete is sealed, you will be ready to finish the job. The job is typically completed with sanding, finishing, and then filling. Sanding will remove material from the molds as well as the panels. Finishing will remove excess sealant that can be applied over the cement and adding additional sealant is important to keep the concrete from drying out.