How do I reset the support code 5b00 on Canon G2000?

Solutions to fix the canon g2000 error 5b00 that appears on the Canon 5B00 error code in the g2000, g3000, the g2002 printer, and the g2010. This error code uses the following techniques.

This article discusses the causes and solutions to fix the error code 5B00 in the Canon G2000, g3000, and the g2010 printer. This error message by applying the following strategies. You will require V4905 or V5302 Canon software V4905 or V5302 to assist in the solution to this error. I'm hoping this article can resolve your issue.

Fix code 5b00 canon printer

This error message 5B00 on the Canon G2010 series printer stands for waste ink counters overflow. That is a frequent error that happens in all printers. The printer starts to blink the orange and green light alternatingly between 7 and 8 times each time you attempt to scan or print. If you attempt to print something, an error will show up. This could be due to the continued installation of the ink system. It is possible to fix this issue by resetting the system.

How to reset support code 5b00 for Canon G2000?

The first step is to examine for ink level. We should fill the cartridges to half to correct this error. If you have ink that is not full, refill it before continuing the process. It is possible to fix this error with the help of Canon services tools. You can utilize the tools for services V5302 and V4905.

Use the following steps to reset the 5b00—error code.

The first step is to enter the service mode to reset this error code. To do this:

1. Please turn off the printer and disconnect it.

2. Do not forget to place the tray of paper in the printer.

3. Hold and press on the power switch. The green light will turn on.

4. Hold the power button in your hand and press and release the "stop button five times.

5. Release the power switch.

6. Wait until the green light appears steady.

The printer is now operating in service mode.

Launch your application (service software) on your PC when you are in service mode by double-clicking it. Connect your printer using the USB. You will see several options on your computer once you connect your printer. After that, click on 'clear ink counter' and set it as well as the counter to stop ink aborting. Click on the Finish option. Then turn off and on your printer. Check whether the problem was solved or not solved the problem.

If you're unable to enter service mode, you need to be able to repair the EEPROM Chip in the Mainboard to resolve this error message. If you're using Canon's service tools like V3400 or V4200. or for other reasons, you cannot access service mode. Therefore, you need to change with a new EEPROM Chip.