KOE-038 Electronics Engineering ( Syllabus as per AKTU)
Course Outcomes:
At the end of this course students will demonstrate the ability to:
Understand the concept of PN junction and special purpose diodes.
Study the application of conventional diode and semiconductor diode.
Analyse the I-V characteristics of BJT and FET.
Analyzethe of Op-Amp, amplifiers, integrator, and differentiator.
Unit - I: PN junction diode: Introduction of semiconductor materials; Semiconductor diode: Depletion layer, V-I characteristics, ideal and practical, diode resistance, capacitance, diode equivalent circuits, transition and diffusion capacitance, Zener diodes breakdown mechanism (Zener and avalanche).
Unit - II: Diode application: Series, parallel and series, parallel diode configuration, half and full wave rectification, clippers, clampers, Zener diode as shunt regulator, voltage-multiplier circuits special purpose two terminal devices : light-emitting diodes, Varactor (Varicap) diodes, tunnel diodes, liquid- crystal displays.
Unit - III: Bipolar junction transistors and field effect transistor: Bipolar junction transistor: Transistor construction, operation, amplification action, common base, common emitter, common collector configuration dc biasing BJTs: operating point, fixed-bias, emitter bias, voltage-divider bias configuration. Collector feedback, emitter-follower configuration. Bias stabilization. CE, CB, CC amplifiers and AC analysis of single stage CE amplifier (re Model), Field effect transistor: Construction and characteristic of JFETs. AC analysis of CS amplifier, MOSFET (depletion and enhancement) type, transfer characteristic.
Unit - IV: Operational amplifiers: Introduction and block diagram of Op-Amp, ideal & practical characteristics of Op-Amp, differential amplifier circuits, practical Op-Amp circuits (inverting amplifier, non-inverting amplifier, unity gain amplifier, summing amplifier, integrator, differentiator), Op- Amp parameters: input offset voltage, output offset voltage, input biased current, input offset current differential and common-mode operation.
Unit - V: Electronic instrumentation and measurements: Digital voltmeter: Introduction, RAMP techniques digital multimeters: Introduction Oscilloscope: introduction, basic principle, CRT, block diagram of oscilloscope, simple, measurement of voltage, current phase and frequency using CRO, introduction of digital storage oscilloscope and comparison of DSO with analog oscilloscope.
Text /Reference Books:
Robert L. Boylestand / Louis Nashelsky, “Electronic Devices and Circuit Theory,” Latest Edition, Pearson Education.
H S Kalsi, “Electronic Instrumentation”, Latest Edition, TMH Publication.
Meetidehran/ A.K. singh “fundamental of electronics Engineering”, New age international publisher.
Streetman & Banerjee, " Solid State Electronics Devices"
Alok Dutta, "Semiconductor devices and Circuits"
D.C. Kulshreshtha, "Electronics Engineering" (as per AKTU syllabus)
All the documents shared below do not claim any originality and cannot be used as a substitute for prescribed textbooks. The information presented here is merely a collected for teaching assignments. COPYRIGHT IS NOT RESERVED BY AUTHORS. AUTHORS ARE NOT RESPONSIBLE FOR ANY LEGAL ISSUES ARISING OUT OF ANY COPYRIGHT DEMANDS AND/OR REPRINT ISSUES CONTAINED IN THESE MATERIALS. THIS IS NOT MEANT FOR ANY COMMERCIAL PURPOSE & ONLY MEANT FOR PERSONAL USE OF STUDENTS FOLLOWING SYLLABUS.