How We Research
We compare products from their published specs and features; the verdicts below are our independent editorial opinions.
If you want a complete, ready-to-use headworn microphone for voice work, choose Pyle PRO On-Ear Audio; if you need to restore a pair of Jabra on-ear headphones you already own, choose Duyfioa Replacement Ear Pads. These two listings point at completely different jobs, so the right pick comes down to whether you're buying a microphone or repairing a headset.
• Pyle PRO On-Ear Audio — biggest strength: a full omnidirectional condenser mic with a 20Hz–20KHz frequency response, 2k Ohm output impedance and a 4-pin mini XLR connector that works with Shure systems or straight into a studio mixer.
• Pyle PRO On-Ear Audio — biggest trade-off: it's a wired, corded-electric microphone only. No wireless freedom, and no Bluetooth pairing.
• Duyfioa Replacement Ear Pads — biggest strength: a direct-fit leather ear cushion set for specific Jabra models (Evolve2 65, Evolve2 40, Elite 45h) in Pink, with a clear four-step install method.
• Duyfioa Replacement Ear Pads — biggest trade-off: it does nothing on its own. It only fits the listed Jabra models, and you must confirm your headphone model before buying.
• Who Pyle PRO is for: presenters, DJs, MCs, singers, actors and anyone doing speech or voice recording who needs a hands-free mic.
• Who Duyfioa is for: Jabra Evolve2 65 / Evolve2 40 / Elite 45h owners whose original earpads are worn out.
The Pyle PMEMS10 is a headworn condenser microphone, not a pair of headphones. That distinction matters, because the "on-ear" label here describes how the mic sits — a lightweight metal frame that hooks over the ear and puts the capsule right at your mouth. The back electret condenser element is omnidirectional, so it picks up voice from every direction rather than demanding you stay locked in one spot. In practice that means you can turn your head, glance at notes, or move around a stage without your level dropping out.
The spec sheet tells a fairly serious story for the money. Frequency response runs the full 20Hz–20KHz range, sensitivity is rated at -44dB ± 3dB, signal-to-noise ratio is 78dB, and maximum input SPL is 130dB. Output impedance is 2k Ohms ± 30%, which is a high-impedance design — worth knowing if you're patching into a mixer, since it behaves differently from a low-impedance stage mic. It runs on DC 1.5V–10V, and the box includes two windscreens. The 4-pin mini XLR cable is the headline connector detail: Pyle states it works with Shure systems or a direct studio mixer connection.
Who should buy it? Anyone whose job is talking or singing while their hands are busy. DJs, MCs, actors, worship leaders, fitness instructors, presenters and home recordists doing voiceover all fit the brief. The beige, skin-tone finish is designed to blend in rather than stand out, which is exactly what you want on camera or on a stage where a black boom mic would be a distraction. The metal frame is also specifically noted as comfortable for people wearing glasses, hats or headphones underneath — a small detail that matters a lot if you've ever fought with a headset that pinches.
Who should skip it? If you need wireless range, this isn't it — it's corded electric, full stop. If you want a mic that doubles as headphones, look elsewhere; this is a microphone unit only. And if you're shopping for replacement cushions for a headset you already own, this product has nothing to do with that job.
The Duyfioa pads are a repair part, plain and simple. They exist to replace worn, flaking or compressed earpads on three specific Jabra families: the Evolve2 65 (including the 65MS and 65UC variants), the Evolve2 40 (40UC, 40MS and USB versions), and the Elite 45h on-ear wireless headset. Compatibility is the entire ballgame here, and Duyfioa says it clearly — confirm your headphone model before purchase. If your headset isn't on that list, these won't fit, no matter how similar it looks.
The material is leather, and the pads ship in Pink. Dimensions are listed at 2.75 x 0.79 x 3.54 inches, which is the kind of compact footprint you'd expect from on-ear cushions rather than big over-ear cups. There's a one-year manufacturer warranty backing them, which is a reasonable signal for a consumable part that takes daily wear.
What I like about this listing is the installation guidance, because pad swaps are where people usually wreck things. Duyfioa's method is sensible: grip the pad edge and pull outward gently to detach it from the shell, avoiding hard pulling at a single point. Then wipe dust and debris out of the headset groove so the new pad seats cleanly. Match the L/R marks, align the buckles with the slots, and press evenly around the edges until everything clips in. Finally, give the pad a light tug to confirm it's firm before you put the headset back on. Follow that order and you avoid the classic mistake of yanking one corner and cracking a mounting tab.
Who should buy it? Anyone whose Jabra Evolve2 65, Evolve2 40 or Elite 45h still works fine electronically but feels unpleasant to wear — flattened foam, cracked coating, or that flaky debris that ends up on your ears. If the headband and electronics are healthy, fresh cushions are the cheapest route back to a comfortable headset. Who should skip it? Owners of any other headphone brand or model, and anyone hoping these pads will change how their headset sounds rather than how it feels.
• Best for hands-free voice and speech work → Pyle PRO On-Ear Audio. Omnidirectional pickup, 20Hz–20KHz response, and a headworn frame that keeps your hands free.
• Best for restoring a headset you already own → Duyfioa Replacement Ear Pads. Direct-fit cushions for Evolve2 65, Evolve2 40 and Elite 45h.
• Best for stage, DJ and MC use → Pyle PRO On-Ear Audio. The 4-pin mini XLR works with Shure systems or a direct mixer connection.
• Best for glasses, hats or headphone wearers → Pyle PRO On-Ear Audio. Pyle specifically notes the metal frame accommodates all three.
• Best for on-camera invisibility → Pyle PRO On-Ear Audio. The beige skin-tone finish is intended to blend in rather than draw the eye.
• Best for a quick, tool-free fix → Duyfioa Replacement Ear Pads. Four steps, no soldering, no wiring — just clip the new pads into place.
• Best if you need wireless → neither. Pyle's mic is corded electric and Duyfioa's pads are a passive part; there's no Bluetooth in either.
• Best if you're unsure what you're buying → re-read the listings. One is a microphone, one is foam and leather. They solve different problems.
In my opinion, most people searching this comparison should buy the Pyle PRO On-Ear Audio. It's a complete, working piece of kit — a back electret condenser mic with a wide frequency range, a 78dB signal-to-noise ratio and a connector that plays nicely with Shure systems and studio mixers. If your goal is to be heard clearly while your hands are busy, that's the product that actually does the job.
I'd only point you to the Duyfioa pads if you already own a Jabra Evolve2 65, Evolve2 40 or Elite 45h and the cushions are the only thing wrong with it. In that specific case, they're the smarter buy — there's no reason to replace a functioning headset when a set of leather pads and four minutes of work will do. Just confirm your model first, because fit is everything with replacement parts. Either way, check the current price on Amazon before you commit.
FAQ
An over-ear headset has larger cups that fully enclose the ears instead of pressing against them. Neither product here is an over-ear headset: Duyfioa's pads measure 2.75 x 0.79 x 3.54 inches, sized for compact on-ear Jabra models, and the Pyle unit is a microphone with no earcups at all.
For the Pyle PMEMS10, the metal frame hooks over your ear so the omnidirectional capsule sits near your mouth — Pyle notes the frame fits comfortably over glasses, hats or headphones. For the Jabra models the Duyfioa pads fit, you simply match the L/R markings when installing and wear the headset as normal.
To swap the Duyfioa pads, grip the edge of the old ear pad and pull outward gently to detach it from the headset shell — avoid yanking hard at a single point. Wipe dust from the groove, align the new pad's buckles with the slots, press evenly until it clips, then tug lightly to confirm a firm fit.
As an Amazon Associate I earn from qualifying purchases.
We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon and affiliated sites.
When you buy through links on this page, we may earn a commission from qualifying purchases at no extra cost to you.
Amazon and the Amazon logo are trademarks of Amazon or its affiliates. This site is an independent third-party review and is not affiliated with, endorsed by, or sponsored by Amazon or the product brands mentioned.
See also: SINOWO Replacement Earpads vs L LTGEM Replacement Ear Pads, headphones replacement ear pads, SoloWIT Replacement Ear Pads vs YangBu Replacement