We compare products from their published specs and features; the verdicts below are our independent editorial opinions.
Updated: 2026-09-18 · 7 min read · Independent comparison
If you want a wired in-ear monitor with a proper dual-magnet dynamic driver and a secure over-ear fit for critical listening on a budget, choose NALMOPG TRN MT1; if you need wireless freedom with LDAC hi-res audio, 30 hours of playback and dual-device switching, choose FiiO EH11.
• NALMOPG TRN MT1 — biggest strength: A dual-magnet 10mm dynamic driver paired with a 5μm silicon crystal composite biocellulose diaphragm, tuned for resolution and speed in a wired 3.5mm package.
• NALMOPG TRN MT1 — biggest trade-off: It is fully wired, has no microphone, and relies on your phone or player for noise control — no battery, no Bluetooth, no app.
• FiiO EH11 — biggest strength: LDAC Bluetooth at up to 990kbps, a 40mm long-stroke driver with bass down to 17Hz, 30 hours of playtime, and app-based EQ plus a gaming mode.
• FiiO EH11 — biggest trade-off: It is an on-ear design with no 3.5mm jack at all, so you are locked into Bluetooth and dependent on charging.
• Who the MT1 is for: Listeners who want a wired IEM for music, monitoring and calls-free focused sessions.
• Who the EH11 is for: Commuters, gamers and multi-device users who want wireless convenience with hi-res codec support.
The MT1 is a classic wired in-ear monitor built around one idea: get more out of a small driver. TRN uses a dual-magnet design that increases magnetic flux by roughly 55%, close to 1 tesla, which in plain terms means the driver moves with more control. More control usually shows up as better dynamics and a snappier sense of speed — the kind of thing you notice on busy rock mixes or layered electronic tracks where cheaper drivers smear detail together.
The diaphragm is the other half of the story. It is a 5μm silicon crystal composite biocellulose unit, and TRN claims it is about twice as efficient as a conventional biocellulose diaphragm. Efficiency matters because it means the MT1 can be driven easily by a plain smartphone rather than demanding a dedicated amp. With 22Ω impedance and 106dB sensitivity, that claim lines up with the spec sheet — these are easy-to-drive numbers. The frequency response is listed at 20Hz–20KHz, the standard full-range window.
Buy it if you want a wired IEM for focused listening, you like the idea of an over-ear cable routing that stays put, or you want a replaceable-cable design you can maintain. Skip it if you need Bluetooth, a microphone for calls, or app-based sound tuning — the MT1 offers none of those.
FiiO EH11: Who It's For
The EH11 is a different animal entirely: a retro-styled on-ear Bluetooth headphone that borrows the transparent mechanical look of 1980s on-ears and adds a wood-grain control knob you can operate by feel. That knob is not just decoration — it handles volume and track control without you needing to look, which is genuinely useful when you are walking or working.
Under the hood, FiiO went after bass. A 40mm long-stroke dynamic driver with a high-damping composite diaphragm drops the resonance frequency to 60Hz and extends bass down to 17Hz, so the low end reaches deeper than most on-ears at this level. The semi-open back design is a deliberate compromise: it keeps some sense of openness in the sound while still giving you a degree of listening privacy. Note the honest trade-off — FiiO lists noise control as "None," so this is not a noise-cancelling headphone. The semi-open build also means it leaks a little and lets a little in.
Wireless is where it earns its keep. LDAC support pushes transmission up to 990kbps, roughly three times the rate of standard SBC or AAC, which gets you near-lossless quality if your phone supports LDAC. You can connect two devices at once — say a laptop and a phone — and switch between music, calls and video without re-pairing. The FIIO Control App adds EQ presets like Pop and Rock, plus a gaming mode tuned to push footstep and gunshot detail, backed by a built-in HD microphone. Battery life is rated at 30 hours from a 1.5-hour charge.
Comfort is clearly a priority: about 92g total with a low 1.7N clamping force, which is light enough for long sessions. The foam ear pads are detachable for cleaning and replacement, and two pairs in different colors are included.
Side-by-Side: Which Should You Choose?
• Best for wired, zero-latency listening → NALMOPG TRN MT1. No Bluetooth codec, no lag, no charging.
• Best for wireless freedom and long sessions → FiiO EH11. 30 hours per 1.5-hour charge.
• Best for bass depth → FiiO EH11. Bass extension to 17Hz with a 40mm long-stroke driver.
• Best for passive isolation and a locked-in fit → NALMOPG TRN MT1. Over-ear hook routing plus an in-ear seal.
• Best for hi-res audio over Bluetooth → FiiO EH11. LDAC at up to 990kbps.
• Best for calls and gaming → FiiO EH11. Built-in HD mic plus a footstep-tuned gaming mode.
• Best for multi-device users → FiiO EH11. Simultaneous connection to two devices.
• Best for easy-to-drive, amp-free listening → NALMOPG TRN MT1. 22Ω and 106dB sensitivity.
• Best for repairability → it is close, but the MT1's replaceable 2-pin cable and the EH11's detachable ear pads both help you keep either one going longer.
In my opinion, the FiiO EH11 is the better buy for most people in 2026 — but only if you live a wireless life. The combination of LDAC, 30-hour battery, dual-device switching, app EQ and a gaming mode covers far more everyday situations than a wired IEM can. That said, I would pick the NALMOPG TRN MT1 without hesitation if you want a wired IEM for focused music listening, monitoring or anything where latency and charging are dealbreakers. If your priority is deep bass, hi-res Bluetooth and all-day comfort, go EH11. If your priority is a cable, a seal and a driver built for speed, go MT1. Either way, check the current price on Amazon before you commit.
FAQ
No. FiiO lists noise control as "None." The semi-open back design gives you some listening privacy but not active noise cancellation. If you need isolation, the MT1's in-ear seal is the stronger option.
This version has no microphone, so it is not intended for calls. It is a music and monitoring earphone. For calls and gaming chat, the EH11's built-in HD microphone is the one you want.
Both are designed for it, in different ways. The EH11 is about 92g with a low 1.7N clamping force and replaceable foam pads. The MT1 weighs 8.2g with a shell shaped for fatigue-free wear and an over-ear hook. In-ears suit some people better; on-ears suit others.
As an Amazon Associate I earn from qualifying purchases.
We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon and affiliated sites.
When you buy through links on this page, we may earn a commission from qualifying purchases at no extra cost to you.
Amazon and the Amazon logo are trademarks of Amazon or its affiliates. This site is an independent third-party review and is not affiliated with, endorsed by, or sponsored by Amazon or the product brands mentioned.