New things we learned were not to miss any steps prior to pulling down the roof. We only had one good pull today because we either forgot to break the sheet rock, cut the studs on the opposite side, or both. Wires can cause plenty of resistance as well and held back a lot of what we were working on.
The floor was our primary focus today. I thought that the best way to dismantle it would be to try and flip it over by pulling it with a cable in sections. No only did this not work, it made a bigger mess than necessary. It took us most of the morning to clean up a 12 foot section.
Mobile Demo Video Download
Download Zip 🔥 https://cinurl.com/2yGcbD 🔥
2. Remove the outside ledger board nailed to the ends of the floor joist. We beat these off with a sledge hammer and an axe. On some occasions we had to saw them or beat a hole in the floor to remove them, but very rarely.
3. In sections of what equals about 2 to 3 floor joist, flip over the section on to the existing floor by putting a person on each end of the last joist and lifting it until it breaks. On some occasions we had to help the break line with an axe.
The only surprise today was the fact that the flooring was so damn heavy. This was due in part by some light rain we had the previous week. The good thing is that the damn particle board broke apart easier. We were very please by the end result today and Alaina actually is getting excited about the project now.
We did it! It is done! We had about 24 feet of floor left this moring and we completed it in about 1.5 hours doing the steps above. By noon we had the first secton of the frame cut up with the torch and by 3:00 we were completely finished with the entire area cleared of any mobile home parts The only things left were a water spigot, septic inlet, and a power pole.
The Frame when really fast with the torch. I cut the center angle iron cross beams out of the middle and cut the I beam where they had been joined at the factory. When we got down to the axles I cut the shakles to the springs off and left them laying for futher dismantling. One torch equalls a one man job so Alaina and Dave relocated all of the support cinder blocks while I was working on the frame.
The Axels were bent so I cut the hardware off the ends to retain the pipe for future projects. The rest went to the trash pile. We slid the frame sections to an area out of the way. Some of these will be skids for a future tool shed. The dead men were pulled out with a high lift jack and chain.
The Picture below shows the parameter of the mobile. Look closely and you can see where the skirting was buried. Techically you could say that the 3 of us are standing in what use to be the shower.
please tell me any info you have concerning the demo cost of a 71 obile home in shelton washington Im concerned about saving the 60 ft shelter that is covering it and hope that some of the alum and siding can be sold
thanks
jill
Thanks for the great documentation and very helpful comments. I have the same problem facing me in the next couple of weeks. Some suggested to get a burn permit and take a match to it. Apparently this takes a few minutes and results in a pile of ash and a steel frame. I am not sure if I like to go that route so I am back to demolition.
Most of the material was burned on site. All of the plastic, windows, insulation was hauled to the dump. We had enough metal on site (including the property) that we were able to get a scrap yard 60 miles a way to bring a 40 yard container. We filled it and gave them the scrap in trade for hauling it off.
Connecting the mobile and desktop user experience is essential for many organizations to remain competitive in the market. Learn how Pendo can help create a connected digital experience for your customers across your mobile and web product portfolio to deliver seamless, omnichannel user guidance.
Until today, demoing your mobile app could prove difficult or even impossible, resulting in missed revenue opportunities. This is a shame, considering that your mobile app may set your sales motion apart and serve as a key competitive advantage.
Today, even if your sales team can demo their mobile app, it's not easy. Cable connections and 3rd-party apps can lead to broken demos. During mobile demos, unprofessional home screens and embarrassing notifications can derail a deal.
With Demostack, set up your mobile demo once for the whole org, empowering sales to showcase your mobile app without the need for repetitive setups. Demo it alongside your web app demos from one unified platform that is built for demoing. No distractions or pop-ups.
To demo your mobile app with Demostack, you'll need to perform a one-time implementation. Demostack will generate a shareable link for your mobile app. This link can then be used alongside web app demos. This one-time implementation frees sales from connecting a mobile phone forever. No R&D needed.
Sharing your mobile app during a demo is straightforward. Utilize the shareable link created with Demostack and perform a screen share from your desktop. This allows you to showcase both your web app and mobile app side-by-side in real-time.
Absolutely. After a call with a prospect, you can create and send a Demostack Sandbox link. This enables your champion and other stakeholders to independently explore the app without your presence in the room.
You could use this app here: to mirror your iPad/iPhone screen to your desktop and then record it with Storyline. Or you could use the simulator that comes with the iOS software development kit and record the app that way. here is a sample of that: _SL/iPhoneRec/
So, I have installed the trial version of Reflector and it is exactly what I wanted except for one thing. I have no way of showing my "finger" (i.e. where I am tapping). Does anyone have a solution for this? It seems silly to have to go to all the trouble of filming a demo with a camera, just to show the hand/fingers.
I ran into the same problem with a course I was developing. We found the best way to get demos was to actually video someone using the app on the device. I'm also experimenting with a ELMO/Document Camera like this one: -Point-View-USB-Camera/dp/B002UBPBTC
Mariann, this looks like a good alternative, thanks for sharing the link! So far, I have shied away from an actual video recording because I could never get the lighting quite right. I would love to see a sample of a recorded video.
I am currently using Articulate 360 to create an interactive demo on how to use our mobile app. I am using reflector, but am unsure how you break down the video for the end user to click along. Do you have to individually capture "screen shots" and add hot spots and text interactions for the end user to get the feel?
Are you recording the Reflector element with Storyline or another tool? I haven't seen that set up yet, so I don't know if it would capture the individual clicks and actions of a user. As you mentioned adding in the hot spots and captions would be a way around that set up.
Note: We will try our best to schedule the demo on the specified date/time. If for some reason we were not able to schedule on the same day, we will re-schedule it at our mutual convenience.
Bank of America participates in the Digital Advertising Alliance ("DAA") self-regulatory Principles for Online Behavioral Advertising and uses the Advertising Options Icon on our behavioral ads on non-affiliated third-party sites (excluding ads appearing on platforms that do not accept the icon). Ads served on our behalf by these companies do not contain unencrypted personal information and we limit the use of personal information by companies that serve our ads. To learn more about ad choices, or to opt out of interest-based advertising with non-affiliated third-party sites, visit YourAdChoices powered by the Digital Advertising Alliance or through the Network Advertising Initiative's Opt-Out Tool. You may also visit the individual sites for additional information on their data and privacy practices and opt-out options.
Fees apply to wire transfers. Other financial institutions involved may also charge fees and deduct their fees from the amountof the wire transfer. See the Online Banking Service Agreement for details. Data connection required for online and mobile transfers.
The app I submitted has someone type in their phone number, and we connect them via SMS to another user who's also installed and used the app. So, in order to see how the app works, the App Store team needs to verify a phone number.
Update 06/2020: The answer below is obsolete. Simply providing a video of your application is no longer enough to satisfy the review requirements. You will need to provide a valid userid/pw and full access to your app. In my case I created a test account in my TEST environment and gave Apple temporary access while the review was going on.
I have a similar although not identical issue with my app. It is very difficult to provide a demo account. An alternative, which is what I do, is to provide a video showing how the application works. In the Notes section you provide a link to the video (I use youtube). I no longer provide a demo account, I just update the video when my app's functionality changes dramatically.
PyTorch Mobile provides a runtime environment to execute state-of-the-art machine learning models on mobile devices. Latency is reduced, privacy preserved, and models can run on mobile devices anytime, anywhere.
In this blog post, we provide a quick overview of 10 currently available PyTorch Mobile powered demo apps running various state-of-the-art PyTorch 1.9 machine learning models spanning images, video, audio and text.
This app demonstrates how to use the PyTorch DeepLabV3 model to segment images. The updated app for PyTorch 1.9 also demonstrates how to create the model using the Mobile Interpreter and load the model with the LiteModuleLoader API.
We really hope one of these demo apps stood out for you. For the full list, make sure to visit the iOS and Android demo app repos. You should also definitely check out the video An Overview of the PyTorch Mobile Demo Apps which provides both an overview of the PyTorch mobile demo apps and a deep dive into the PyTorch Video app for iOS and Android. 152ee80cbc