Design Projects
Design Projects
Embedded Files
Parts designed in SolidWorks
Clutch paddle system for UofL's Formula SAE car. This system allows the driver to pull the paddle with their fingers while the lever pivots on an axis in the center, providing enough force to push the piston on the clutch master cylinder in to send hydraulic fluid through the system to actuate the clutch.
Coilover suspension that has a damper running up and down inside the tube, with the spring around the tube, and the coil nut adjusting the spring height, allowing adjustment of a car's ride height.
Simple three spoke design steering wheel that has a common six-bolt pattern and a horn button. Deep dish style steering wheel, commonly seen in drift cars.
Piston and connecting rod assembly made for a simple V6 engine
Crankshaft made for a simple V6 engine
Rocker arm assembly for a simple V6 engine
Simple V6 engine block
Cylinder heads for V6 engine
Mass air flow block off plate for an 8th generation Toyota Corolla with a 1ZZ engine with the factory airbox. This goes in the factory MAF sensor location, and converts it to fit a 3/8" NPT intake air temperature (IAT) sensor. This conversion is for use with a Link FuryX standalone ECU which reads IAT instead of MAF.
Reverse engineering of a Kobalt 40V push lawnmower
Part with complex shapes and contours with the purpose of learning complex toolpaths with the use of a CNC mill
Rubber gasket for the fuel tank access cover for a BMW E30
Improved design of the axle and spindle assembly of a International Harvester Cub Cadet lawn tractor
Above and left: Design of a 4 spur gear assembly encased in a gearbox
Page updated
Google Sites
Report abuse