Additive Manufacturing 

Criteria

Must be designed in SolidWorks

Prepared in a slicer for additive manufacturing

3D printed in PLA filament

The object cannot take up more space than as 80mm sphere.

Unlike the previous year, you must create a ring to fit over the vertical monitor support.  Make sure to use a caliper to measure.  Don’t rely on a peer’s measurements.  The object will then somehow be attached to the side of the ring so that the other student from the other class can also display their  project on the other side of the support.

Test prints for the ring support are required before full prints (this has to be displayed on the ePort).