Linksys Extender Setup

Install a Linksys Extender Setup That use the WPS Push Button

To help you in trying to setup your Linksys Extender with the WPS Push button, carefully follow the steps described below. These instructions will help you in setting up your Linksys Extender Setup without problems.

Make sure that your Linksys Extender does have a WPS button when you're setting it up. Ensure that the extender has indeed been purchased and that all of the packaging tapes have been removed. After that, put your Extender into your power outlet and set it on.
The following step to finding the WPS button on your extender and gently press it. Press the WPS button on your router, which is found on the back of your router, at the same time.
Check if the WPS LED light on your router and extender is blinking later; this indicates that your extender is successfully connecting with your router.

Remember that even if you want to upgrade your network from 2.4 GHz to 5 GHz, you'll need to click the WPS button on both your router and your extender.

Consider relocating your extender as quickly as possible after that. You can do this by disconnecting your extender from the wall outlet and moving it to a different location. Make sure your new location is somewhere between your router and the clear spot you want to extend the network to.
After that, check the WPS LED lights on your Linksys Extender Setup for seeing if they should be turned green. The extender's green light indicates that you'll be receiving a good internet range. If you get a red light, you need to move the extender nearer to your router's range.
Finally, you must correctly connect your computing device to the Linksys extended network.