Embedded Files
Wooden Engineering Requirements
Wooden Engineering Requirements
Wooden Engineering 16-17.pdfDesign Proposal
Design Proposal
My Idea was to create an small desk dwore with a wireless charger on the top
The idea was to put a small peace of wood on the otside of the progect to be used as a cord holder
the origanal idea was to have it be able to firr a walit and keas inside however only keas weare able to fitt
I first had to cur out the wood from some 2x5 and had to cut them to get 5 peace's of 2x5x6 (of those two of them were 1x5x6)
The next step was to glue the peace's together to form a box.
I than use the band saw to smooth the eges than cut out both dwors
The next step was to jount the peaces of the dwore back togther and glue them together to form the dwore
After the dware was formed the next step was to sand to make sure all sides are perfictly straghr and no sharp corners than sandit a lip in the front to open and close it
The last step was to stain the wood to have it all be the same color
After It finished drying it was complete and was now ready to be used
I wish I was able too fit an wallet into it however other than that everything went exactly how I wanted it to be
Page updated
Google Sites
Report abuse