The Power2U AC USB wall outlet is a useful addition to any home or office. It allows you to charge your USB devices directly from the wall, eliminating the need for bulky adapters and freeing up your outlets for other uses. Installing the Power2U outlet is a relatively simple process that can be completed with basic tools and some knowledge of electrical wiring. Here's how to do it.
Power2U AC USB Wall Outlet
Screwdriver
Wire stripper
Voltage tester
Electrical tape
Wire nuts
Turn off the Power
Before you begin, it's important to turn off the power to the outlet you'll be replacing. Locate the circuit breaker or fuse box that controls the outlet, and turn off the switch or remove the fuse. Use a voltage tester to confirm that the power is off.
Remove the Old Outlet
Use a screwdriver to remove the screws holding the old outlet in place. Gently pull the outlet out of the wall box, and disconnect the wires from the screws. Take note of which wires are connected to which screws.
Connect the Wires to the Power2U Outlet
Using a wire stripper, strip about half an inch of insulation off the ends of the wires. Connect the black wire (or red wire if present) to the brass screw on the Power2U outlet. Connect the white wire to the silver screw, and the green or bare wire to the green screw. Use wire nuts to secure the connections, and wrap each one with electrical tape.
Attach the Power2U Outlet to the Wall Box
Carefully tuck the wires back into the wall box, and align the Power2U outlet with the screw holes. Use a screwdriver to attach the outlet to the wall box using the provided screws.
Test the Outlet
Before turning the power back on, use a voltage tester to check the outlet for any live wires. Once you've confirmed that it's safe, turn the power back on and test the outlet with a USB device to ensure that it's working properly.
Safety first: Always turn off the power to the outlet before working on it, and use a voltage tester to confirm that there are no live wires.
Make sure you have the right tools: You'll need a screwdriver, wire stripper, voltage tester, and wire nuts to install the Power2U outlet.
Take note of the wires: Before disconnecting the old outlet, take a photo or make a diagram of which wires are connected to which screws. This will make it easier to connect the wires to the Power2U outlet correctly.
Follow the instructions: The Power2U outlet comes with detailed installation instructions. Be sure to read them carefully before beginning the installation process.
Test the outlet: Once you've installed the Power2U outlet, test it with a USB device to make sure it's working properly. If you have any issues, refer to the troubleshooting section of the installation instructions or contact the manufacturer for assistance.
Here is how to Install the Power2U AC USB Wall Outlet, Installing the Power2U AC USB wall outlet is a simple and worthwhile upgrade to any home or office. With just a few basic tools and some knowledge of electrical wiring, you can enjoy the convenience of charging your USB devices directly from the wall. Just remember to follow all safety precautions and installation instructions to ensure a safe and successful installation.Â