Embedded Files
Step 1: Assemble the front ring parts. F;G,H;H2*
cable exit top or bot
cable exit left or right
Step 2: Install all non-hollow pillars, using the M4x10mm Screws. Do not over-tighten those, only screw so much that the pillar is rigid and doesn't wobble.
Step 3: Install the LED strip and cut to length.
Step 4: Install the Hollow Pillars one by one, and connect the back ring parts. A;B,B2*;C
Pay attention, the back rings are offset from the front rings.
cable exit top or bot
cable exit left or right
Step 5: Continue completing the rings one by one, ensuring that every pillar is positioned correctly inside the grove.
cable exit top or bot
cable exit left or right
Make sure you've installed all screws. Every Pillar and segment should be screwed together, and nothing should be wobbly.
Step 6: Installing the USB Cables and Camera Heads.
6.1: Feed the three USB cables through the hollow pillars for every camera.
6.2: Pull the USB cable through the Camera Heads.
6.3: Screw down the Camera Heads using M4x10mm screws or, even better, if you have longer screws up to a maximum of 18mm length.
6.4: Install Cameras using the M2x6mm screws or leave them like this for later install.
If you have purchased the HBV OV2710, you will have an extended frame on the camera. Do not be afraid to just break it off on the red lines. Just use some pliers and do not be afraid to damage it, there are tiny pre-drilled holes at this position, which ensure you do not break off at the wrong place.
Step 6: Install the cables cleanily on the back side. If needed use some small tape pieces to prevent the cables from falling out again if thats the case.
Yellow: USB Cable Blue: LED Cable
cable exit top or bot
cable exit left or right
Make sure you are exiting at the right position. In this version, there are 3 possible exits, 2 of which are diagonal. Just make sure you are exiting where the LED cable is fed through.
Step 7: Only at the very end, when the system is fully assembled, I would recommend sliding in the collar.
Do this step if you bought the garden privacy protection strips. In Europe, it is quite easy to find these, for example, online or in a hardware store. You can also get custom ABS plates online using the dimensions below. Just make sure it's not thicker than 3mm. The correct length and width are 235cm x 16,5cm.
Feel free to reach out to me in the Discord nd I will help you find an available alternative in your country.
I used this one: https://amzn.to/498vs9i
Slide in the Collar
Overlap slightly and mark it.
Cut the collar. And reinstall.
If you find any errors, missing information, or have trouble understanding the manual, please let me know on my Discord.
Page updated
Google Sites
Report abuse