Very vibrant in color, an has good bed adhesion out of the package, but it has lost of trouble with the infill. I go this for free at RMRRF 2024. Very flexible. Also as you can see from the photo, this filament strings like there is no tomorrow. (For people new to TPU, TPU-95 is harder and more plastic like when compared to it's brother, TPU-90 which is closer to rubber.) But take into consideration that the printer I made this on has a Bowden extruder, which is why the print quality is crap.

Here is the link to the model in the photo:

Other than the fact that this filament does string a tiny bit, I really have no other complaints about this filament. In the picture you can see that the filament prints AMAZING out of the package. And the Matte lime green color really stands out. All in all, this has to be some of the best filament I have EVER printed with. If you are reading this and work for polymaker, then props for you because this filament is awesome. (also the photo looks a bit off because i sliced this for a 1.0mm nozzle but accidentally printed it in a 0.6mm nozzle)

Here is the link to the model photo:

The army red filament is exactly like the lime green filament. The quality is the same. So for a quality review, please see above. That being said, the color is very good. The texture is also very similar to the lime green pla, it is rough. I can compare it to extremely fine sand paper. The benchy came out very well, the text on the bottom is very readable. Remember, this is printed in a 0.6mm nozzle

Here is the link to the model photo:

This purple filament has the is the same this as the red, and the green filaments. The only difference is that this is purple. I don't want to sound like a broken record. So please refer above.

Here is the link to the model photo:

This filament was just newly launched when I had purchased it. It shares the same over all matte look and great print quality as the polyterra filaments. But when you feel the filament, it feels very smooth, it has the same great matte looks but has a very appealing texture. I really like this!

Here is the link to the model photo:

Ok, this filament is actually terrible. The filament feels really rough and porous (Lots of tiny little holes and the filament). The print quality of the filament is terrible. Polymaker has made very good filament but this is not good filament. This is lightweight PLA and that might explain the rough texture, but there is no excuse for the bad quality.