Transmission swaps, custom wiring & mechanical troubleshooting
I’ve spent much of high school working on friends’ and local cars, sometimes as paid work. Most projects began with something not working correctly and turned into hours of diagnosing, removing parts, figuring out how systems fit together, and putting everything back together.
A lot of my work has involved transmission swaps and related wiring, including custom wiring needed to make manual-conversion projects function correctly.
I worked on several transmission rebuilds and swaps across cars including a Subaru Outback, Lexus IS300, C5 Corvette, and Pontiac Trans Am. These projects involved removing driveline components, fitting replacement transmissions, reconnecting surrounding systems, and troubleshooting problems after installation.
Removing and installing a transmission during a manual-swap project.
Custom wiring prepared for a manual conversion project.
Manual swaps were not only mechanical. I also worked on custom wiring needed to make the converted cars operate correctly, tracing circuits, modifying harnesses, and troubleshooting connections after installation.
Testing the manual shifter and related systems after installation.
After installation, I checked the surrounding systems and worked through problems that appeared during testing. Those moments usually taught me the most because a problem could come from the mechanical installation, wiring, fitment, or something I had assumed was unrelated.
I usually start by narrowing down the symptoms instead of immediately replacing parts. I check the systems around the failure, test assumptions, and work backward until I understand what is actually wrong. Cars taught me that one small issue can affect an entire system, and that the first explanation is not always the right one.