Departing aircraft
Green flag.
"09R" -> Departure runway,
"AY1340"-> Flight number,
"1" -> Departure sequence number (slot) for the given runway.
"00:33" -> Departure countdown (takeoff must be initiated within +/-15s for on time).
Aircrafts without flag cannot be selected cause they are currently parked.
Repositioning aircraft
Orange flag. Aircraft on tow. These aircrafts are subject to repositioning on the airport. Blue arrow shows direction towards target parking position.
Selected Flight
Flags of non-selected flights are transparent. Selected flight is bright and has a blue rotating circle.
Flight information
-> Aircraft type and size (Heavy, Medium, Light)
-> Departure / Arrival / Repositioning
Objective Departure:
-> Departure runway
-> Take-off time
-> Departure sequence.
-> Take-off run. 15 seconds maximum or end of runway which ever is earlier.
Objective Arrival/Repositioning:
-> Taxi to indicated parking position. Parking position might still be occupied. It will be available within the next minutes.
Take off position indicator
Green/red lead lights indicating take off position. At red take-off is not permitted. Green means wake-turbulence separation to previous departure is fine but it doesn't mean that runway is not blocked by any other traffic.
Waketurbulence countdown
Countdown for proper seperation of previous departure on this runway. In addition the runway color in the overview panel is also set to red in order to remind you that take-off is not permitted.
Taxi, line up and take off controls
-> Cancel: cancelling lineup or take off -clearance.
-> Line up 04R: Line up on runway 04R. Can be combined out of a taxi clearance to a holding point.
-> Take off 22: Take off on runway 22. can be combined out of a taxiclearance to a holding point together with a lineup clearance.
-> Hold Position: Stop aircraft right now.
-> Taxi: Begin a new taxi clearance. See construction of a taxi clearance below.
Taxi clearance constuction controls
-> Ignore Parkings: If ticked, for better overview it won't show any unnecessary parking positions for the taxi clearance (less buttons on screen).
-> Reset: Resets current taxi clearance.
-> Cancel: Cancelling taxi, lineup or take off -clearance.
-> Hold short of: Hold before next clicked taxiway (e.g. in order to keep it clear for another aircraft).
Taxi controls general
-> Close: Deselect current flight.
-> Hold Position: Stops aircraft immediately. New taxi clearance construction required in order to move again. Visible only after issuing taxi clearance.
-> Stop Taxi: Stop moving right now. Taxi clearance remains valid and also indicated as a yellow line. Visible only after issuing taxi clearance.
-> Continue Taxi: Continue taxi after using the stop taxi function. Aircraft continues on the previously constructed taxi clearance which is still indicated as a yellow line. Visible only after stopping.
Taxi clearance construction
Yellow solid line -> Temporary taxi path.
Blue solid line -> currently inspected taxiway (the last clicked taxiway).
White arrows -> crossing taxiways (from currently inspected taxiway). Indicates possible paths. Each taxiway button represents a possible continuation of the path.
Taxiway button
Click to add taxiway to temporary taxi path. Keep in mind that you cannot select another flight during the construction of a taxi clearance. Only way out is with cancel or close.
Taxiway width indication is located in the upper right corner on the button (Heavy/Medium/Light). Be careful when moving larger aircraft on a smaller taxiways. This is possible but wing-tip-clearance cannot be assured.
Taxi clearance construction terminates when hold short function was armed before.
Holding point / stopbar / parking button
Click to execute now taxi clearance to given stop. Holding points give new flight control options for line-up and take-off.
Taxi clearance construction terminates.
Target parking position
Target parking position is indicated by a blue circle. Target parking is always shown for arriving and repositioned aircrafts.