Coca~Cola Container

First, a small slit must be cut into the label part of the bottle to fit one blade of the scissors in. After inserting the scissors, you must proceed to cutting the bottle in half.

Next, after setting the top half aside for later use, the rest of the label is cut off leaving the bottom grip. (Only cut off the red)

This next part is a bit tricky. On the side of the bottle there are striped ridges that should be cut to create flaps. To give the flaps more support you must cut down to about the red line shown to the right on each ridge stripe leaving one ridge stripe in between (Ex: cut a stripe, leave a stripe, cut a stripe, leave a stripe, etc.). When cutting remember that it is better to cut too short than too long.

If your creation can fold down and stay, then congratulations! You did it!

If you are having any trouble with it working then try making this again. With practice you will learn what cut length works best. If only a couple of flaps are not sticking then you can try cutting farther or bounding it in a rubber band and running water over it. I would recommend is rounding the corners of the flaps so they do not poke you while they are being used.