Embedded Files
Challenge Objective - 3D model an object that represents you. This must be of your own design and fit the top of the monitor. Unlike the previous year, you share this computer station with another student from another class. As you build your model, refer to the following criteria
Challenge Objective - 3D model an object that represents you. This must be of your own design and fit the top of the monitor. Unlike the previous year, you share this computer station with another student from another class. As you build your model, refer to the following criteria
Criteria:
Criteria:
- Must be designed in SolidWorks
- Prepared in a slicer for additive manufacturing
- 3D printed in PLA filament
- The object cannot take up more space than as 80mm sphere.
- Unlike previous years, you must create a ring to fit over the vertical monitor support. Make sure to use a caliper to measure. Don’t rely on a peer’s measurements. The object will then somehow be attached to the side of the ring so that the other student from the other class can also display their project on the other side of the support.
Initial frame of carpet bag
Initial frame of carpet bag
Then planing and thickening the model
Then planing and thickening the model
(Ignore the cylinder on bottom, the instruction for the product changed)
(Ignore the cylinder on bottom, the instruction for the product changed)
Fillet added to faces of the bag
Fillet added to faces of the bag
(GIF) The steps for the handle hinges
(GIF) The steps for the handle hinges
The first iteration of the zipper, using extrusion
The first iteration of the zipper, using extrusion
Adding a linear pattern to make the zipper
Adding a linear pattern to make the zipper
And finally, adding the ring to fit onto the desk pole
And finally, adding the ring to fit onto the desk pole
And the part is done!
And the part is done!
Page updated
Google Sites
Report abuse