Brother Printer Drum Error Troubleshooting and Routine Maintenance
Brother Printer Drum Error Troubleshooting and Routine Maintenance
The Brother printer is the best for offices and educational institutions. Sometimes documents completely depend on the printer. Therefore, it gets necessary to have a quality printer at your place. The brother drum printer error is a common error that occurs on this printer as well. Let's take a look at what this error is and ways to detect it, and then a Fix Brother Printer Drum Error to resolve it.
Every machine eventually reaches the end of its life-cycle. At some point, it may stop working and start displaying error messages. This may also be the case with Brother Printers. In some cases, your Brother machine may display “Brother Printer drum error” or “Brother Printer drum end soon”. The likely reasons for these errors include the following:
* The corona wire on the drum unit of your Brother Printer might not be clean
* The drum unit of your Brother Printer has reached the end of its life
How to clean Brother Printer drum?
If you receive the error to replace your drum printer, you need to purchase a new brother drum printer and install it on the previous one. This is a separate unit that can be replaced after 3 or 4 toners cartridges are used. It will help you out to Fix Brother Printer Drum Error if you take the drum printer out and clean it out. If you realize that this error is not relevant, you can fix it again by returning the drum printer. So, basically, there are two most commonly used ways to resolve the drum printer error: to replace it or fix the error by finding the best possible way.
There are two ways to resolve Brother laser printer drum errors: either repair it or replace it. Here we show you how to fix drum error on the Brother printer. There are different types of consumables available for Brother printers, including toner cartridges and drum units. Make sure that the substitute you choose is the drum unit, not the cartridge. To clean the Brother Printer drum, you need to clean the corona wire on the drum unit. For this,
* Turn off the machine and remove all the cables attached to it.
* Now, open the front cover and take out the drum unit and cartridge assembly slowly.
* Slide the green tab to and fro several times and clean it gently.
* After this, set the drum unit and the toner cartridge assembly in the printing machine.
* Close the front cover and reconnect all the cable.