Review the following chart and correspond with the lights that are on the dash. If a Regen is needed, please follow the steps below.
The Regen button is found near the bottom of the steering wheel
The only button we need to regen is the far left switch
The following steps must be followed to reset a regeneration light that does not go off after driving unit.
The unit must be driven first and the engine temperature must be at 180 degrees or higher.
Unit must be parked on level ground and the parking brake set (button pulled out) and wheel chocks put under tires.
Place unit into drive for 10 seconds and put back into neutral.
4. The parking brake must be released (button pushed in) and then reset again (button pulled out so unit cannot roll) and the truck must remain running.
5. On the left side of the steering shaft where it goes through the floor you will find 3 switches with red covers on them so they cannot be accidentally pushed. They will read Request, Inhibit and Diagnostics. You need to push the Request button and hold it down for 3-5 seconds and the regen light will go out.