Pin-on-Disc Tribometer - Rotary Type
Make: Ducom Instruments - POD 4.0
Load Range - 1 N to 200 N
Track Diameter - 10 mm to 50 mm
Sample - ASTM G99 Standard Pin and Ball (4 mm, 6 mm, 10 mm in diameter and 15 mm in length)
Temperature range of Ambient to 1000 °C (Operating Temperature - Ambient to 950 °C
Compliant with ASTM G99 Standards
DYNAMIC MECHANICAL ANALYZER
(Facility under Central Instrumentation Facility (CIF))
Make: Perkin Elmer - DMA 8000
Dynamic range of 0 to 600 Hz
Temperature range of -190 °C to 400 °C
Compliant with ISO 6721 tests
Five Modes of Tests possible - Single Cantilever, Dual Cantilever, 3 Point Bending, Tensile and Compression
SPLIT HOPKINSON PRESSURE BAR WITH BALLISTIC ATTACHMENT
(Facility under Central Instrumentation Facility (CIF))
Make: Artis Technologies - SHPB & SHTB with Ballistic Attachment
Striker Bar Velocity - up to 50 m/s (SHPB & SHTB)
Ballistic Velocity - 100 to 300 m/s
Barrel Diameter - 32 mm, Barrel Length - 2500 mm
Bullet Mass - 5 g to 8 g, Bullet Diameter - 8 mm to 10 mm (Special Fixture should be used for holding the bullet)
IR Camera to capture the ballistic impact
GAS PYCNOMETER
(Facility under Central Instrumentation Facility (CIF))
Make: Anton Paar - Ultrapyc 5000
Helium charged
Sample Size range - 4 to 135 sq.cm
Can be used for powder samples, solid samples and semi-solid samples (with less moisture content)
PARTICLE SIZE ANALYZER
(Facility under Central Instrumentation Facility (CIF))
Make: Anton Paar - PSA 1190
Dry and Wet modes
Capable to measure the particles of size 40 nm to 2400 µm
Powdered samples can be sonicated and homogenized into distilled water or any suitable solvent (whose refractive index is known) to run in wet mode
VICKER'S MICRO-HARDNESS
Make: Struers - Duramin 4
Micro-Hardness testing
Load range of 1 g to 120 kg
50x resolution
OPTICAL MICROSCOPE
Make: Zeiss - AXIO
50x Resolution Micro-structure Study
Samples should be mounted or supported to view the micro-structure
SHORE D HARDNESS
Make: Elcometer 3120 Shore D
Suitable for Medium to Hard materials
Compliant with ASTM D2240, DIN 53505, ISO 868, ISO 7267-2 Standards
DYNAMIC UTM
(Facility under Central Instrumentation Facility (CIF))
Make: Walter+Bai
Maximum load capacity - ± 250kN
Test Capabilities: High cycle Fatigue test, Low Cycle Fatigue, Fatigue Pre-cracking, Crack growth, K IC, J IC , Tensile, Plastics Tensile, Fatigue properties of plastics, Composite materials Tension – Tension Fatigue.
Type of test(s): Load controlled, position control, and strain control.
Test Materials - Metallic materials, High-strength alloys, Polymers, Polymer Composite materials like FRPS.
All the equipment in the laboratory is available for Research and Consultancy works with a nominal fee payment
People with relevant Research interests are welcome to use the lab facilities (Nominal standard charges apply). Please contact jack.kenned@nitpy.ac.in to use the lab facilities.