Download Winbox 3.19

After I updated a RB2011UiAS-2HnD from 6.44.3 to 6.45.1 I can not log into it remotely with winbox. Nothing changed other than the upgrade. I know the user and password I am use is correct but this is the log file error I get:

Winbox.exe is signed with an Extended Validation certificate, issued by SIA Mikrotkls (MikroTik). WinBox uses ECSRP for key exchange and authentication (requires new winbox version). Both sides verify that other side knows password (no man in the middle attack is possible). Winbox in RoMON mode requires that agent is the latest version to be able to connect to latest version routers. Winbox uses AES128-CBC-SHA as encryption algorithm (requires winbox version 3.14 or above).

Download Zip 🔥 https://blltly.com/2y84fB 🔥

Unfortunately, I don't get it running.

My intended setup is:

WAN Port 1, LAN Port 2-4, DtD Port 5.

AREDN Node is a Nano Station Loco running 3.19.3.0 firmware.

The router is a MikroTik RB952Ui-5ac2nD HAP AC Lite.

I followed your instructions. Result is, that my PC and the router get a DHCP address from the Loco, but the Mikrotik isn't able to get a dhcp address from my home internet router. Thus, the loco has no WAN IP and my PC is also not able to access the internet.

I have some questions concerning the VLAN config.

Using your VLAN 30 or removing it and changing the bridge name to vlan 1 (and the settings on vlan1_ether1) has no effect, I also get no internet.

VLAN 31 isn't assigned in the Mikrotik. Since I don't use another switch for assigning vlans at home, I would have to configure something similar to your vlan 31 in the mikrotik, I think?