Laser Manufacturing and Application Laboratory

EXPERIENCES

University of Manchester Visiting PhD student Department of Mechanical, Aerospace and Civil Engineering, 

Project Assistant Researcher,National Experimental Research Institute Taiwan Instrument Science and Technology Research Center,Taiwan

Postdoctoral Researcher,Institute of Atomic and Molecular Sciences,Academia Sinica,Taiwan

RESEARCH INTEREST

1.Laser Welding Batteries

2.Sweat Sensor

3.Terahertz Setup

4.AI Gas Sensor

Journal Papers 

SCI journal paper

1. Ankit Das, Aniruddha Ghosh, Somnath Chattopadhyaya, Chien-Fang Ding*, A review on critical challenges in additive manufacturing via laser-induced forward transfer, Optics & Laser Technology, 2024. 

2. Ankit Das, Samarpan Deb Majumder, Chien-Fang Ding*, Feasibility evaluation of nanofluid based solar collector for biodiesel hot wash: An experimental study, Solar Energy, 2022.

3. Che-ShuLin, Hsin-Fang Hsieh, Chien-Fang Ding, Kuan-MingLi, Hong-TsuYoung, Wen-TseHsiao, Laser surface modification on rGO/ZnO composite materials for NO2 gas sensing, Materials Chemistry and Physics, 2022.

4. Chien-Fang Ding, Yin-Te Lan, Hong-Tsu Young, Wen-Tse Hsiaoa, Enhanced conductivity of the Poly(3,4-ethylenedioxythiophene)-poly(styrenesulfonate) (PEDOT: PSS) films using pulsed CO2 laser irradiation, Synthetic Metals, 2021.

5. Chien-Fang Ding, Yi-Cheng Lin, Ching-Ching Yang, Chun-Ming Chang, Kuo-Cheng Huang, Shih-Feng Tseng, Keh Moh Lin, Wen-Tse Hsiao, Surface Modification of Addition Manufactured Ti–6Al–4V Alloys by Ultraviolet Pulsed Laser Scanning Technique: Morphologies, Roughness And Electrical Properties, Journal of Laser Micro/Nanoengineering, 2021.

6. Kuan-Yi Hung, Yi-Tse Chang, Chih-Hsuan Chien, Chien-Fang Ding*, Ming-Chih Tsai & Hong-Tsu Young, “Investigation of ink modification for aerosol jet printing process on FR-4 substrate, International Journal of Advanced Manufacturing Technology, 2020.

7. Ta-Wei Tang, Wei-Han Kuo, Jauh-Hsiang Lan, Chien-Fang Ding*, Hakiem Hsu, Hong-Tsu Young, Anomaly Detection Neural Network with Dual Auto-Encoders GAN and Its Industrial Inspection Applications, Sensors, 2020.

8. Chien-Fang Ding, Lin Li, Hong-Tsu Young, “Laser-induced backward transfer of conducting aluminum doped zinc oxide to glass for single-step rapid patterning,” Journal of Materials Processing Technology, 2020.

9. Chien-Fang Ding, Wen-Tse Hsiao, Hong-Tsu Young, “Evaluation of structural properties of AZO conductive films modification using low-temperature ultraviolet laser annealing,” Ceramics International, 2019.

10. Chien-Fang Ding, Meng-Shiou Lee, Kuan-Ming Li, “Low-Cost Camera Based Laser Power Monitoring and Stabilizing for Micro-Hole Drilling,” International Journal of Precision Engineering and Manufacturing, 2017.

11. Chien-Fang Ding, Wen-Tse Hsiao, Hong-Tsu Young, “Effect on the electro-optical properties of transparent conducting aluminum doped zinc oxide thin films using low temperature ultraviolet laser annealing,” Journal of Materials Science: Materials in Electronics, 2017. 

      International conference paper

1. Ta-Wei Tang, Wei-Han Kuo, Jauh-Hsiang Lan, Chien-Fang Ding, Hakiem Hsu, Hong-Tsu Young, The industrial application and the method of improvement of GANomaly, 631ST International Conference on Science, Engineering & Technology, 2020.

2. Donyau Chiang, Chien-Fang Ding, Yu-Ting Li, Yi-Cheng Lin, Po-kai Chiu, Hsin-Yi Tsai, “Assessment of Frying Oil Degradation using Laser Direct Writing Interdigital Sensors,” IEEE International Instrumentation & Measurement Technology Conference (I2MTC), 2020. (EI)

3. Chien-Fang Ding, Yi-Cheng Lin, Ching-Ching Yang, Kuo-Cheng Huang, Yu-Jen Hsiao, Wen-Tse Hsiao, “Fabrication of Tin Oxide Based Gas Sensor in Ethanol Gas Sensing,” IEEE Sensors Applications Symposium (SAS), 2020. (EI)

4. Chien-Fang Ding, Ching-Ching Yang, Chin-Lin Kuo, Yu-Chen Hsieh, Chih-Chung Yang, Kuo-Cheng Huang, Wen-Tse Hsiao , “Indium Tin Oxide Films Based pH Concentration Sensor Fabrication and Verification Using Pulsed UV Laser Patterning Technology,” IEEE Sensors Applications Symposium (SAS), 2020. (EI)

5. Yu-Chen Hsieh, Yi-Cheng Lin, Chien-Fang Ding, Kuo-Cheng Huang, Wen-Tse Hsiao, “Hybrid laser patterning and modification technology of indium tin oxide conductive films applied for alcohol concentration sensing,” 15th International Conference on Laser Ablation, 2019, Maui-Hawaii, USA, 2019.

6. Ching-Ching Yang, Chien-Fang Ding, Chih-Ning Hsu, Kuo-Cheng Huang, Wen-Tse Hsiao, “Pulsed UV laser surface modification of indium tin oxide films applied for pH concentration evaluation,” 15th International Conference on Laser Ablation, 2019, Maui-Hawaii, USA, 2019.

     Domestic conference paper

1. Cheng-Tien Chiang, Prabesh Bista, Chien-Fang Ding, Development of laser-based photoemission spectroscopy and microscopy. 2022 Annual Meeting of the Physical Society of Taiwan, 國立臺灣師範大學 (2022).

2. Chien-Fang Ding*, Cheng-Tien Chiang, Difference frequency generation of terahertz waves for time-resolved photoelectron spectroscopy. 2022 Annual Meeting of the Physical Society of Taiwan,國立臺灣師範大學 (2022).

3. 洪瑞慶, 丁健芳, 高熵合金在潛變試驗中樣品夾具外徑與試片尺寸影響分析, 中國機械工程學會第三十七屆全國學術研討會論文集, 2020.

4. 吳禮揚、丁健芳*, 謝欣芳, 洪瑞慶, 蕭文澤, 楊宏智, 還原氧化石墨烯經雷射表面改質後之材料特性, 中國機械工程學會第三十七屆全國學術研討會論文集, 2020.

5. 丁健芳, 李義雄, 蔡心怡, 蕭文澤, 雷射微結構圖案化於矽晶圓上之PDMS轉印製程, 還原氧化石墨烯經雷射表面改質後之材料特性, 中國機械工程學會第三十七屆全國學術研討會論文集, 2020.

6. 謝欣芳, 丁健芳*, 蕭文澤, 楊宏智, 雷射表面改質於還原氧化石墨烯複合材料對NO2 氣體感測效能影響之探討, 中國機械工程學會第三十七屆全國學術研討會論文集, 2020.

7. 侯軒雅,蕭文澤,鄭璧瑩,邱柏凱,丁健芳,蔣東堯, 雷射參數變化對玻璃內部改質以及吸收率的研究, 中國機械工程學會第三十七屆全國學術研討會論文集, 2020.

8. Ching-Ching Yang, Yi-Cheng Lin, Chien-Fang Ding, Kuo-Cheng Huang, Wen-Tse Hsiao, Development of a touch-type force sensor with the highly sensitive on hybrid conductive PEDOT: PSS / AgNW film, 中國機械工程學會第三十七屆全國學術研討會論文集, 2020.

9. 吳禮揚, 丁健芳, 蕭文澤, 楊宏智, 雷射直寫製程技術於奈米碳管之微型加熱器製作, 中國機械工程學會第三十六屆全國學術研討會論文集, 2019.