How To Install a DSTV Satellite?

To install your DSTV satellite, you need the following hardware and tools:

- Dstv decoder

- Dstv approved satellite dish

- Wall bracket

- Coax cable

- Various connectors

- Dstv approved LNB for the specific type of installation

- Fasteners, cable ties, amalgamated tape

- Hammer action electric drill

- Drill bit

- Socket or spanner

- Hammer

- Electrical power extension

- Ladders

- Safety harness

- Safety goggles

You also need to run the DSTV installation wizard on your decoder to choose your settings and connect to the satellite. The steps are different depending on your decoder model and LNB type. Here are some general steps:

1. Press the blue “DStv button”

2. Use the right arrow to go to “Settings”

3. Scroll down to “Satellite Settings”

4. Then choose “Home Network”

5. Select “Launch Installation Wizard" and then press “OK” on the remote.

6. Choose the satellite that matches your country. If you are in South Africa and neighboring countries, then select “IS 20.”.

7. Select “Manual Setup” for the HD decoder or "Quick Setup" for the Explora decoder.

8. Set the LNB type based on your installation (e.g., "universal" for a single or twin LNB).

9. Select "Scan" and then press “OK” on the remote.

10. Wait until your decoder finishes scanning.

If you need more detailed instructions, you can check out this guide. Alternatively, you can contact an accredited DTV installer near you for assistance.

Call Now! 081 723 7979