Dental Inlays and Onlays Auburn

Inlays and Onlays in Auburn

Inlays and Onlays

Traditionally, inlays were used instead of fillings to replace a small amount of tooth structure loss due to decay. Like fillings, inlays fit inside the tooth and were made only of gold.

Dental Inlays

Today, inlays are still used in the same situations, but the inlays can be made of a tooth-colored material such as ceramic/porcelain or special dental composite. Defective or unsightly “fillings” can be replaced by tooth-colored inlays and bonded to the tooth. This bonding process may actually improve the strength of the tooth and help seal the inlay to the tooth.

Dental Onlays

Onlays also fit inside the tooth, but extend onto the chewing surface of a back tooth to replace one or more cusps. In the past, onlays were made only of gold, but like inlays, more and more patients request a tooth-colored onlay. Making the onlay of ceramic/porcelain allows the restoration to be bonded to the tooth. This bonding process may actually improve the strength of the tooth and help seal the onlay to the tooth.

It is difficult to determine when inlays or onlays can be used instead of crowns or caps. Ask your prosthodontist if you are a candidate for a tooth-colored inlay or onlay.

There are times when a tooth suffers damage (from decay, for example) that is too extensive to be treated with a simple filling — but not extensive enough to need a full-coverage crown. In these cases, the best option for restoring the tooth may be an inlay or onlay.

Inlay and Onlay.

Both inlays and onlays are considered “indirect” fillings, meaning that they are fabricated outside the mouth (generally at a dental laboratory), and then bonded to the tooth by the dentist. This is in contrast to a “direct” filling, which is applied directly to the cavity by the dentist in one office visit.

An indirect filling is considered an “inlay” when it fits within the little points or “cusps” of a back (premolar or molar) tooth. It is an “onlay” if it covers one or more of these cusps. Either way, the procedure for placing an inlay or onlay is the same.

How It Works

Getting an inlay or onlay is very much like what you would experience having a crown placed, with one important distinction: less of your natural tooth structure will need to be removed by drilling when you receive an inlay or onlay. When you get a crown, the tooth needs to undergo significant reshaping so that it will fit inside its new covering. Since dentistry's goal is to preserve as much of your natural tooth structure as possible, inlays and onlays may be recommended instead of crowns when a tooth can be restored with this more conservative type of treatment.

The first steps in getting an inlay or onlay are numbing the tooth and surrounding area with a local anesthetic, and then removing the decay. This is done in order to prevent the decay, which is actually a type of infection, from progressing deeper into the tooth.

Once the tooth has been prepared, an impression of it is made (either digitally or with a putty-like material) and sent to the dental laboratory. There, the impression is used to make a model of your tooth for the creation of your inlay/onlay. The final restoration can be made out of gold or a tooth-colored ceramic or resin.

Before you leave the office, a temporary filling will be attached to your tooth to protect it until the permanent restoration is ready. At your second visit, the permanent inlay/onlay will be attached to your tooth with either a resin that hardens when exposed to a special light source, or a type of permanent cement.

Inlays and onlays are strong, long-lasting, and require no greater level of care than any other tooth. Conscientious daily brushing and flossing, and regular professional cleanings at the dental office are all you need to make sure your restoration lasts for years to come.