[Academic Projects]
[Academic Projects]
PCB board design applying signal integrity principle
PCB board design applying signal integrity principle
Board designed to demonstrate switching noise with good and bad layout
Copy of Good_bad_laypout_board_Hexinvertre.pdf
NE555 timer is used as an astable vibrator that drives four LEDs. Series resistance of LEDs are varied to measure the relative brightness and total current drawn from the output pin of 555 timer.
555_timer_board_design.pdfCrystal oscillator and mechanical switch lab work.pdfCurrent_carrying_capacity_transmisisonline.pdfSwitching_nosie_root cause and solution Labwork.pdf 2.4 GHz RF Microstrip bandpass filter for WLAN
2.4 GHz RF Microstrip bandpass filter for WLAN
For wireless and communication systems, bandpass filter using microstrip coupled line operating at center frequency of 2.4GHz with 10% fractional band width is designed.
2.4GHz_BandpassFilter_design_EM_simulation.pdf
Analysis of TDR to measure low cost Dk constant
Analysis of TDR to measure low cost Dk constant
My role in this project is to develop method to measure the physical dimension of the board and perform consistency test with the result achieved from measured and ADS simulation result using analytical equation.
Analysis_of_a_TDR_Technique_to_Measure_Dielectric_Constant.pdfMicrostrip patch antenna design
Microstrip patch antenna design
Finl_report_.docxPublished paper in Automation and control
Published paper in Automation and control
MATLAB and TI DSP processor
MATLAB and TI DSP processor
Model-Based_Sensored_Field_Oriented_Control_Implementation_for_Permanent_Magnet_Synchronous_Motor.pdf