Photo Documentation

I will have to cut these steps off the side of the feeder so that the gates will fold up properly.

I am cutting metal for the gates to the right measurements.

I am marking where I will need to cut the metal.

I will have to cut an angle so that it will fit in the gate.

I cut the angle in the metal with a die grinder to get the perfect angle.

I am measure the metal to mark it where i need to cut it at.

I have to grind the old welds off so I can weld the feeder to the frame because the welds broke and the feeder tips backwards.

I welded the bottom of the feeder to the frame.

I am tack welding the side of the gates together

I am cutting the flat steel for the angles so that I can drill a hole and have it pivot so the feeder can fold up.

I am finishing the welds on the sides of the gates so that they are not just tack welded.

I drilled a hole in the flat steel and into the feeder, i had to do that for it to pivot and fold up.

I am grinding the steps off.

The gate is all finished and ready to be used.

Gates folded up