Motion

For this assignment, I learned how to control a servo motor. Moreover, I learned how to move objects using servo mechanisms. I also used an ultrasonic distance sensor. I applied computational thinking skills like pattern recognition by analyzing what sensors that I need to use and looking for a repeating sequence where I need to put each wires in the correct location from the previous project.

The most difficult part of this assignment was putting the electronic components in the correct location. There was a time when I put just one electronic component in the wrong place and my LED failed to blink. I really need to be careful and thorough during the installation because it was easy to mix up between numbers and letters in the red-board. The letters and numbers were so small, so I feel like it was hard to see which part should I need to put. Last but not least, the resistors were very hard to apply to the breadboard as it was so tiny and thin.