Electrical Safety

You should know these electrical, power, and safety rules:

1. Electrical equipment - Operate within its capabilities. Do not overload circuits.

2. Grounding - A two prong tool is double insulated by design an may have a plastic housing reducing the chances of electrocution of the user. A three prong tool is wired using a safety ground so it provides a wired path to ground.

3. Inspect tools - Do not use electrical tools with frayed, split, cracked, or bare wiring.

4. Extension cords - are not permanent connections. If that’s where the equipment is going to remain and be used, have it professionally “hard wired”

5. Repairs - Do not repair electrical tools and equipment yourself, particularly in a professional environment. That’s what electricians are for.

6. Modifications - If this tool cannot be plugged into that receptacle, there is a reason. Any modifications regarding electricity are never the way to make these problems go away.

7. Follow Procedures:

• Do not stand in water and use electricity.
• Before you plug it in make sure it is switched to “off”.
• When you are done with the tool unplug it
• Do not leave it running while you walk away.
• If you need to service the tool unplug it of lock it out
• Use a vice to clamp your work
• Inspect tool components for damage
• Use safety guards

8. When using air - use safety glasses. Do not blow air at anyone or use it to clean yourself or the shop. Do not spin bearings with air.

9. When working with batteries always wear safety glasses.

10. If electrolyte (sulfuric acid) contacts your skin or eyes, flush with water for several minutes (holding your eyelid open). Do not rub your eyes or skin. Contact a doctor.

11. Batteries are charging or discharging vent quantities of hydrogen gas. Any spark or source of ignition will cause you to be sprayed with acid when the battery explodes. Always follow precautions when working with batteries.