Embedded Files
Tools We Used
Tools We Used
Drill Press, Hand Drill, Hoe, Trowel/float, Power Mitre Box, Table Saw, Tri Square, Protractor, Router with 1/4 round and ogee, Screw Gun, Pencil, Tape Measure, Clamps, hammer, Orbital Sander, Drill Bits, rulers, Table Saw, Band Saw.
Safety
Safety
Wear Safety Glasses when using power equipment
Wear Safety Glasses when using power equipment
Keep a neat clean work area
Keep a neat clean work area
Remove loose jewlery
Remove loose jewlery
Tie long hair back away from work
Tie long hair back away from work
Don't use broken or cracked electrical cords
Don't use broken or cracked electrical cords
Mass Production Milieu
Mass Production Milieu
Economy of Scale
Efficiency: out/in
Standardization of Parts: all parts are the same
Interchangeable Parts: every part of its kind can be used, it doesn't matter what part you choose
they're all the same
Lower Cost/Prices:created by mass production which in turn creates an economy of scale
design & dimensioning
design & dimensioning
Prototypes
Ideas
Experimentation
Inovation
Materials & Material Properties
Materials & Material Properties
Pine/fir/plywood, polyvinyl acetate(PVA) adhesive (wood glue), steel, cement+sand+stone+water=concrete
Pine/fir/plywood, polyvinyl acetate(PVA) adhesive (wood glue), steel, cement+sand+stone+water=concrete
Strong, Hard, Flexible, moisture/water resistant, durable.
Strong, Hard, Flexible, moisture/water resistant, durable.
separation - cutting, routing, drilling, shaping, sanding are some of the processes of manufacturing we used
separation - cutting, routing, drilling, shaping, sanding are some of the processes of manufacturing we used
Following the plans and making sure the measurements are correct!
Following the plans and making sure the measurements are correct!
We use jigs and fixtures to guarantee standardized parts and assembly for the pursuit of efficiency and so that all of the output is the same and conforms to the original design
using jigs
using jigs
what we used
what we used
in
in
our class:
our class:
FASTENING AND ADHESIVES - PUTTING THINGS TOGETHER: The assembly process
FASTENING AND ADHESIVES - PUTTING THINGS TOGETHER: The assembly process
Movie on 5-8-18 at 8.17 AM.movfinishing - looking good and protecting
finishing - looking good and protecting
Movie on 5-7-18 at 2.07 PM.movThe Final Product
The Final Product
Universal Systems
Goal: To Mass Produce 15 - 18 Nightstands with concrete tops
Inputs: Money, Wood, Screws, Workers, Machines and Tools, Adhesives.
Processes: Cutting, Drilling, Attaching, Forming, Quality Control, and Safety.
Feedback: Parts Fit, Joints are tight, joints are open, table is solid.
Output: Completed Tables, scrapwood, sawdust, left over materials.
Report abuse