TU-X1 Shipping Damage Repair

I have removed all the wiring and connectors from the rear. Below are some pictures of the bare rear panel.

Here is the cut out where the Furutech IEC jack also known as Rong Feng SS-7B was installed. Note how sloppy the hole enlargement was done. There are burrs still clinging on the edges. I've already removed one piece that got caught on my finger. There is no excuse for not removing excess material that will either end up injuring a person or causing an electrical short that might cause fire.

The tool mark around the hole suggests that a rotary handheld cutting tool like a Dremel was used to make the hole bigger from the outside. The tech lacked a very simple tool called a file to clean up the edges.

This page was created 2017-08-13, last updated 2017-08-13