Printing out AMPLINEX information

There are three ways to print out the information seen within AMPLINEX.

You can print out an AMPLINEX file as it is displayed on the screen from within AMPLINEX; you can print the files themselves as you would any other text file; or you can load the files into your own word processor and re-format them as required before printing.

1) To print a file from within AMPLINEX choose the 'SET PRINT ON/OFF' option from the Introduction menu. This allows you to toggle a software 'print switch' on or off. If the switch is set ON then any AMPLINEX file which is displayed on the screen will be sent to the printer. This will continue until you set the switch off again using the same Introduction option. An asterisk is displayed at the top of the screen next to the issue number when the print option is ON and the print status is shown at the bottom right of the screen as text is displayed within AMPLINEX.

2) If you prefer to print the parts you require outside of AMPLINEX - all the data is held in files on the AMPLINEX disc. The files are in directories named according to the sections in which they appear and the file names can be seen at the foot of the screen as they are displayed in AMPLINEX so you can make a note of the ones you require.

The file directories allocated to each section of AMPLINEX are as follows:

$. for Music

A. for the Introduction and Adverts

F. for Features

H. for Hints and Tips

I. for Instruments

N. for News and Reviews

Q. for Questions and Answers

U. for Utilities

In addition to the text files, the AMPLE instrument definitions can also be printed directly from within AMPLINEX. Music and utility programs written in AMPLE can only be printed by LOADing the programs into the Studio 5000 and using the WRITE command (see Studio 5000 User Guide page 100).

3) If you wish to re-format the text before printing you should load the files into your word processor. The files contain unjustified text restricted to 38 columns width. The files contain only printable ASCII characters except for a control code (ASCII 11) which marks the screen page breaks. View treats these as left margin tabs and if necessary they can be removed with a C/^L// command.

Two utilities have been published in AMPLINEX to aid with the re-formatting of text files:

In AMPLINEX 003’s Hints and Tips (H.ints003) there were instructions for a Wordwise segment program to automatically format AMPLINEX text files. The segment itself was included in AMPLINEX 004 (H.WWconv).

In AMPLINEX 005 there was a utility to print formatted 80-column text direct from an AMPLINEX text file. The instructions (U.print/i) and the BASIC program (U.print80) are both within the Utilities section. A modification to this program (to provide a wider margin) is included in this issue's Hints and Tips section.