GBS10 - BASIC M17 - revision 1.7 (2017-08-08)
GBS10 - PRO M17 - revision 1.2 (2020-04-25)
GBS10 - PRO M17 - revision 3 (2025-06-04)
GBS10 - A3CONNECT M17 - revision 1.3 (2018-10-16)
GBS10 - Engine cutter - revision 1.4 (2017-08-08)
GBS10 - Tough-G2 - revision 4A (2020-10-08)
GBS10 - Tough-G2 - revision 5 (2021-10-13)
GBS10 - Tough-G2 - revision 6 (2021-11-05)
GBS10 - Tough-G2 - revision 7 (2021-11-09)
GBS10 - Tough-G2 - revision 8 (2023-10-05)
Note: to change the CAN bus speed from 250kbps to 1Mbps directly via CAN bus, send next commands:
Set 1Mbps
Send to Tough-G2 - CAN-ID: 0x7D0, DLC: 8, Data: 0x01 0x0D 0x68 0x00 0xA0 0x00 0x00 0x08
Receive from Tough-G2 - CAN-ID: 0x7D1, DLC: 5, Data: 0x01 0x0D 0x68 0x00 0xA0 0x00 0x00 0x08
Store to non-volatile memory
Send to Tough-G2 - CAN-ID: 0x7D0, DLC: 4, Data: 0x01 0x00 0x06 0x5A
Receive from Tough-G2 - CAN-ID: 0x7D1, DLC: 4, Data: 0x01 0x00 0x06 0x00
TOUGH2 - cables pinout - revision 2/panel no angle (2024-04-10)
TOUGH2 - cables pinout - revision 3/panel right angle (2024-04-10)
TOUGH2 - Deploy signal on Small panel - r1 (2024-08-29)
GBS10 - Training pyro - revision 1 (2017-06-07)
GBS10 - Emergency buzzer - revision 1.1 (2017-06-07)
GBS10 Config Application - User manual - revision 1 (2023-02-20)
GBS Config (2021-12-07), for windows 10, including libraries
GBS Config (2023-02-06), for windows 10, including libraries
Note: support Tough-G2 unit only via USB-CAN interface with SLCAN protocol