Jacuzzi & Bath
お風呂

Bath Controller

1. Press the ON/OFF (入/切) button to turn it on. Open the taps to fill the bathtub with hot water.

2. Reheating Function (追い焚き)
   This function reheats the water in the tub. When you press this button, if the water temperature has dropped below the set level, it will reheat immediately.

3. Keep-Warm Function (ふろ保温)
   This function automatically maintains the water at the set temperature.

Please do not add anything other than water to the bathtub (no bath salts, soap, etc.).

If the water is not hot enough and you want to add hotter water, you can set the hot water temperature to 60 °C using the arrow buttons on the control panel. However, please lower the hot water temperature back to 43 °C afterward. Using the shower with 60 °C hot water is dangerous.

Bathtub Cleaning System

1. Press the ON/OFF (運転) button to turn it on.
   
   

2. Deep Cleaning (浄化強)
   Press to start a deep cleaning cycle. Detergent is automatically added, and the cycle runs for 30 minutes.
   
   

3. After Cleaning (アフタークリーン)
   Press this button to initiate a quick cleaning cycle that lasts 2 hours.
   
   

The water temperature is set to 42 °C. Please keep the switch on while filling the bathtub with hot water.

Please reheat and reuse the same water instead of draining the Jacuzzi.