Click on the castle or here to check out student recordings on FlipGrid.

This project is traditionally done using Inventor and then printed on our MakerBot 3d printers, however due to COVID-19 the students learned a new program and created a modified version of the project. Traditionally each part is designed individually and put together as an assembly. The hope is that when we return to Shawnee we will 3d print the castles.

Click on the photo to the left or here to check out student recordings on FlipGrid (project is not due till 6/12, so there may not be any videos available).

The students got to do an "Up to you design challenge"! They had the ability to view two different websites or use the Engineering student's design challenge project. The level of difficulty was up to them.

https://fluxspace.io/fluxosc/

https://sharpen.design/stem/

Click on the boat to the left or here to check out student recordings on FlipGrid.

This was a design challenge done by all Drafting & Design II and Engineering students. The students were not limited to their supplies and could use anything they had around them, they were able to make a boat small for a sink or large for a pool.

Click on the drawing to the left or here to check out student's sketches.

We started COVID-19 with a few sketching assignments. Leading into sectional drawings.