Search this site
Embedded Files
Skip to main content
Skip to navigation
Lil B's Fab
2014+ Toyota 4Runner Hybrid Front Bumper
Open Hood and remove radiator cover
(2020+) Unplug TSS sensor from behind grille
Remove 10mm screws located in each wheel well and under front bumper.
Unplug fog lights from behind rear bumper
Measure 5 3/4” from where the grille and bumper cover meet and make a mark.
Tape off cut line to fender.
Using an Air-saw or cut-off wheel, cut your factory bumper along tape line. (This will be a rough cut)
(2020+ only) Carefully cut grille around TSS sensor using air saw. Sensor will remain in factory location.
Remove Factory crash bar via 8) 14mm nuts.
Remove Factory Skid plate (New bumper/skid combo fits under factory skid)
Test fit Bumper and check clearance
After test fitting bumper go back and make final cut.
3/8-5/8” final gap is preferred
.
Install Winch and Lightbar in new bumper before lifting onto vehicle.
Install Bumper and tighten hardware by hand. (
You will tighten again in last step
)
Install Side Frame Support Brackets and Re-install Factory Skid Plate.
Tighten All Mounting Hardware
Report abuse
Page details
Page updated
Report abuse