By: Cordell
Voltage= 3.00
Amperage= 2.86
Resistance= error
During my researcher I found reoccurring error when it came to resistance, and in all three circuits voltage was consistency 3.00 while Amperage Had different results for circuits three, four, and five consisting of 2.89 for circuit three, 29.6 for circuit four, and for circuit five 5.98. What I found to be strange during my researcher was how high the amperage was for circuit four compared to the other two circuit.
Voltage= 3.00
Amperage= 29.6
Resistance= error
Voltage is the electric difference between two points that is contained in the circuit. Volts are units that represent the electric potential between two points in the circuit.
Voltage= 3.00
Amperage= 5.98
Resistance= error
By: Jaina
V = I * R
3 V = 1.5 mA * 2 kΩ
Both potentiometers and resistors lower the current of electrons in a circuit.
I = V / R
6 mA = 6 V / 1 kΩ
R = V / I
23.6 Ω = 6 V / 254 mA
By: Jonah
In this circuit, I made it so that the resistors weren't directly connected to one another. There is a wire beneath all of them that spreads the energy across all four of them in a parallel circuit, instead of a series.
This allows me to remove one of the LEDs and the circuit still work properly. All remaining LEDs light up in respective fashion. It also shows there being more volts, showing that less volts are being used in this circuit than the prior one.
By: Byron
Circuit
Code
By: Lahna
I watched the video that was provided on echo.
I opened Tinkercad.
I created a new circuit using arduino uno R3, 3 light bulbs, 3 resistors, and a small breadboard.
I followed the coding according to the video.
I saved a screenshot of the circuit and the code.
Starting this nine weeks we will be discussing digital electronics using a Arduino Microcontroller Board. This week we will be discussing Digital Inputs that can control the outputs of the Arduino and some of its features.
By: Cordell
I again used an Arduino Uno 3 and a small Breadboard
this time I used a pushbutton and added two resistors
I also added one LED
I then used wires to connect the Arduino Uno 3 with the small breadboard small
I then used code to improve upon the circuit
https://www.tinkercad.com/things/h9txSF1vpF3