Embedded Files
Plane
Plane
Rc Plane to drop seeds, like Zipline in Rwanda for hospitals
Nappy with Seeds
Nappy with Seeds
Nappy with seeds, same idea as toiletpaper
Air Pressure Cannon
Air Pressure Cannon
Cannon to shoot seedballs like t-shirt cannon
Rhino Charge Car Dispersion
Rhino Charge Car Dispersion
Some sort of dispersion with either the shaking of the car or some other way to spread seeds
Toilet Paper with Seeds
Toilet Paper with Seeds
Toilet paper with seeds inside so after you wipe it acts as fertiliser
Tea Bag with Seeds
Tea Bag with Seeds
Tea bag with seeds, seeds can not impart flavour and must grow from humidity and water
Chosen idea: Rhino Charge car dispersion
Chosen idea: Rhino Charge car dispersion
Idea inspiration:
Idea inspiration:
Hotwheels car booster
Nerf Rival ball Launcher
Pinball Launcher
Pullback Crossbow
Sketches:
Sketches:
Flinger design: Two bendy rods with indent to hold seedballs, pulled back and loaded like crossbow and then flung.
Bucket Car Idea
Bucket Car Idea
A large hopper on the top of the vehicle with tubes, elevated to gain momentum and launch the balls. Agitating done by the shaking of the car
Bucket Car Idea
Bucket Car Idea
A spinning mechanism that makes it so the balls go 1 by 1 and don't come all at once, also makes it so they can get more momentum.
Flywheel Design like Nerf Rival blaster/football launcher
Flywheel Design like Nerf Rival blaster/football launcher
Squishy pinwheels spinning fast that will launch the seedballs, inspired by nerf rival guns and ball launchers for sports.
Pinball Springloaded Design
Pinball Springloaded Design
Springloaded plate that will launch the balls, inspired by pinball machines.
Chosen Design: Flywheel Launcher
Chosen Design: Flywheel Launcher
Materials List:
1. Flywheels:
Soft rubber wheels (RC car tires, foam wheels, or even custom 3D-printed wheels with rubber bands around them or ninja flex)
Higher friction = better
2. 2x Motors:
High-speed brushed DC motors (around 12V or 24V depending on power needs)
3. Motor Controllers:
Electronic speed controller (ESC) or just a basic motor driver (like an H-bridge)
4. Power Source:
Battery pack (Li-ion or NiMH)
Or could use a wall power supply or car battery supply.
5. Frame/Chassis:
Plywood, PVC pipes, or 3D printed parts to mount everything securely.
6. Feed System:
A way to push the seedballs into the wheels like:
Gravity hopper (angled funnel)
Pusher arm (spring-loaded or motorized)
7. Wiring and Connectors:
Wires rated for motor’s current
Solder, heat-shrink tubing, connectors
8. Safety Stuff:
On/off switch
Optional: Fuse for short-circuit protection
9. Extras:
Rubber padding or foam around entry points
Bearings for smoother spinning if needed
Speed controllers or potentiometer to adjust power/speed
Page updated
Report abuse