Print Requests / Bonus Prints

Print Request Form & Bonus Prints:

When 3D printers are not being used to print projects for Applied Engineering & Technology they are busy printing "bonus" prints for students. This is open to all SSI students!

Design something you want to print, build it a 3D modeling program (Onshape), then add it to the Bonus 3D print request for below. You may submit one per form (approximately one per week).

After you fill out the form:

Next step - see Ms. Sykes to set-up colors at the beginning of class.
If you are not in AET right now you will be invited during Advisement within the next week.

Earrings

Important details:

Hole for the earring should be an inside dimension of .0625" (1/16")

The thickness for the earring should be .050" total. If it is too thick it will not attach correctly to the hook.

Croc Jibbets

Important details:

If the Crock Jibbet is too big it will not bend with the shoe, aim for 1inch by 1inch.

Don't worry about adding on the colored extrusions until the end.

Report abuse