Overview of Status of Analysis, Design, Fabrication, Tests, etc.
Final presentation at ATA on Thursday June 2
Research, flapping mechanism, test set up, and three validated wing designs will be presented
We will also be giving a presentation on 3D printers, specifically the ROBO 3D R1 Plus that we used to rapid prototype the wings
This is a key introduction of 3D printing technology to ATA
Accomplishments from Previous Week
Made the final presentation
Test set up calibrated and test data gathered
Identified how we would improve the test set up and wing designs if we had more time
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Work on final poster and report
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Identify the filters necessary for getting useful data
Give more structure to the flat torsional wing
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Be prepared to give a 45 minute technical presentation with audience members interjecting with quesetions
Comments from Other Students in the Class (indicate date of comments and if via email or in person)
Risks and Areas of Concern
Our test set up has 3 degrees of freedom but the load cell only measures vertical force
Future considerations: be able to measure 3 DOF
Resources or Information Required but not Available
Schedule
Describe upcoming milestone
Update Gantt chart.
Budget (list amount spent and amount remaining)
Progress on Report and Webpage