The AUTOMOTIVE SERVICING NC II Qualification consists of competencies that a person must achieve to inspect, clean and repair mechanical or electrical parts, components, assemblies and sub-assemblies of light and heavy-duty automotive vehicle with diesel or gas engine in accordance with manufacturer's specification.

The CARPENTRY NC II Qualification consists of competencies that a person must achieve that will enable him/her to perform fabrication, installation and stripping of formworks, its components and supports.

The COMPUTER SYSTEMS SERVICING NC II Qualification consists of competencies that must possess to enable to install and configure computers systems, set-up computer networks and servers and to maintain and repair computer systems and networks.

The BEAUTY CARE NC II Qualification consists of competencies that a person must achieve to perform pre and post beauty care services, perform manicure and pedicure, perform hand spa, perform body massage, perform body scrub, perform facial treatment, perform foot spa and apply facial make-up.

The Technical Drafting NC II Qualification consists of competencies that a person must achieve to enable him / her to draft architectural layout and detail (structural, electrical/electronic, sanitary/plumbing, and mechanical) drawings using both CAD system and manual drafting methods.

The DRESSMAKING NC II Qualification consists of competencies that a person must achieve to enable him/her to draft and cut pattern; lay-out pattern on the material/fabric, sew material/fabric and apply finishing touches on the ladies casual apparel of the Garment sector.

Furniture Making (Finishing) NC II is a short TESDA course in the Philippines that will train you in preparing surfaces for final coating, applying final coating using spray gun system, and performing basic preventive maintenance servicing for spray gun equipment and booth.

The Electrical Installation and Maintenance NC II Qualification consists of competencies that a person must achieve to enable him/her to install and maintain electrical wiring, lighting and related equipment and systems where the voltage does not exceed 600 volts in residential houses/buildings.

The ELECTRONIC PRODUCTS ASSEMBLY AND SERVICING NC II Qualification consists of competencies that a person must possess to assemble electronic products, prepare printed circuit boards (PCB) modules and to install and service consumer and industrial electronic products and systems.

The Shielded Metal Arc Welding (SMAW) NC II Qualification consists of competencies that a person must achieve to weld carbon steel plate and pipe components as specified by layout, blueprints, diagrams, work order, welding procedure or oral instructions using shielded metal arc welding equipment.