CLMBR02 Assembly Guide

Lay out all parts. DO NOT remove pins installed in upright upper pulleys until machine is fully assembled.

Lower console onto left upright. With upright pins still installed, the pedal or handle can be moved up and down to help align couplers.

Insert pin (A) into upright coupler and console. Ensure the ring on the pin sits flush in the curved surface. Rock the console to help align the holes.

Lower the right upright onto the console.

Insert pin (A) into upright coupler and console.

Rotate the machine down to the floor. 

Plug the console power cord into the right upright jack.

Before removing shim backing, align shim with lower screws on the face of the ankle.

Bend the shim over the lower edge.

Remove the shim and bend it over where the crease was made.

Clean both upright ankles with an alcohol wipe where the shim will be applied.

After alcohol has completely dried, remove shim backing and apply shim to ankle. Ensure no threaded holes on the ankle are covered by the shim.

Hold the u-base above the ankles and plug the cable into the jack on the ankle face

Slide the U-Base onto the upright ankles. Ensure both sides slide on at the same rate and the cable does not get pinched.

Start threading 10 (B & C) bolts with washers (D) by hand in the u-base. Tighten both long bolts first. Then, tighten 4 short bolts on both sides in an “X” pattern. Thread leveling feet (E) into uprights.

Rotate the machine on its side.

Install 2 bolts (G) through one dip bar holder (F) and dip bar into the coupler and console. Repeat for other dip bar. If screws do not start threading, rock console to help align holes. Ensure dip bars curve down and out from under machine.

Push the display tubes all the way forward.

Rotate the machine on its back.

Raise the machine to standing.

Push the display tubes back and slide the display onto the mounting bracket.

Install 2 display mounting screws (I).

Connect power and data cables on back of display.

Slide the resistance knob (H) onto the console housing shaft by aligning the D-profiles. Press down firmly to full seat the knob. Check that there is a clicking sound when the knob is turned.

Remove pin from the upper pulley on both uprights.

Install bottle holder (J) on either upright.

Rock machine back on wheels and move to desired location.

Level machine by adjusting feet underneath the machine.

Connect power supply to u-base

Verify 

- Machine turns on

- Handles adjust smoothly

Start a workout and confirm

- No abnormal sounds at every resistance level

- 1-11 resistance displays on   screen(1)

- 20 inch max reach displays on screen (2)