Overview of Status of Analysis, Design, Fabrication, Tests, etc.
Design circuits
Fabrication
Accomplishments from Previous Week
Built circuit to transmit the signal. (Ahmed)
3-D printed a sleeve. (Dan)
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Send a pulse. (Ahmed)
Receive a pulse. (Anuj)
Have an initial design for the spring mechanism. (Andy)
Finalize the caliper Sleeve design and attach it to the calipers. (Dan)
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Caliper sleeve bulky - cut down at the transducer holder part if possible
Will redesign caliper sleeve
Add finger rests / holders for usability
Will redesign caliper sleeve
Help with coding of micro-controller needed
Will look into coding of his micro-controller and write the code
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Start building the circuits
built a transmitter circuit
Risks and Areas of Concern
Transducer burning out
Resources or Information Required but not Available
Power rating for the transducers
Schedule
Proof of concept presentation
Update Gantt chart.
Budget (list amount spent and amount remaining)
Amount Spent: $771.06
Amount Remaining: $228.94
Progress on Report and Webpage
Finished the impact on society and started the applicable standards section.