SN11 EXX
Selectable 4x4
Driving Category Ba
Diesel Fuel Only
Specific Controls
Small button on top right of square panel
The small round switch is the blue light and siren isolator switch
P = Park
R = Reverse
N = Neutral
D = Drive
The Ratio Selector should be in 2H
2H Rear-wheel drive
When driving on dry paved road.
4H Full-time 4-wheel drive
The basic position for super select 4WD II. When driving on dry paved or slippery roads
4HLc Centre differential lock engaged 4- wheel drive
When driving on rough, sand or snow covered roads.
4LLc Low range centre differential lock engaged 4- wheel drive
When driving up or down steep hills, on rough or muddy roads (especially when increased torque is required).
There is no battery isolator on this vehicle - please ensure all auxiliary systems, internal lights and headlights are turned off when the vehicle is not in use
The suspension on this vehicle cannot be adjusted.
CAUTION
The “4LLc” range gives maximum torque for low speed driving on steep slopes, as well as sandy, muddy, and other difficult surfaces. On vehicles with A/T, do not exceed speeds of approximately 70 km/h (43 mph) in “4LLc” range.
Do not drive your vehicle in the “4HLc” or “4LLc” position on dry paved roads and highways. Doing so may result in excessive tyre wear, increased fuel consumption, and possible noise generation. It may also increase the differential oil temperature, which may damage the drive system. Further, the drive train will be subjected to excessive loading, resulting in oil leakage, component seizure, or other serious problems.
On dry paved roads and highways, drive the vehicle in “2H” or “4H” only
General Principles
Don't leave the vehicle unlocked when parked
Ensure the keys for the vehicle remain on the driver or in a safe location outside the vehicle
Ensure all auxiliary systems, internal lights and headlights are turned off when the vehicle is not in use